Vauxhall vectra
is the pump working? do u feel pressure on the lines to the nozzles?
check nozzles for clogging with salts and check if the pump on the water tank for wiper is getting power or not
let me know
6/19/2009 11:45:43 PM •
Kaz Heater
•
Answered
on Jun 19, 2009
Vectra 2001 2.0dti
Deffo sounds like it, try and source a second hand one though as these are not cheap
3/16/2009 9:31:01 PM •
Kaz Heater
•
Answered
on Mar 16, 2009
Heater won't stay on
This product does indeed have a problem with the safety switch, that is only supposed to kick in when the unit is turned over. I had a total of 3 units sent to me from Kaz. Each time the unit would work for a short time, then slowly begin to turn off and on. I finally decided to take the unit apart and look for any obvious problems. There is a weighted swivel that will raise a contact point to turn the unit off in an emergency. The contact points would spark off and on, depositing a black carbon on them until they would no longer allow power to pass through. I cleaned the contacts with a fine finger nail file and bent one of the contact arms inward to make better tension between the contacts. This allowed the unit to stay on for longer periods of time. But even with the thermo-stat turned all the way up, the unit does not stay on long enough to heat the room. In effect, what happens is the contacts will continue to ark, putting black deposits on the contacts until you're back to square one. Apparently the unit also has a thermo-stat related problem. I'm sending the unit back again (they only made me send the power cord last time), but will insist on a different model this time. Good Luck
Honeywell HFD 135 FAN BLADES DIRTY
I used a can of compressed air to clean my fan blades and this did the job. I bought a 6-pack of 3M Dust Remover at Sams Club to save money. Hope this helps.
George
Not finding what you are looking for?