Jugs Answered Questions & Fixed Issues

The following pages describes location of the serial number you will require before calling JUGS support at 1-800-547-6843. Call them about your query. https://jugssports.com/pages/support-resources/troubleshooting.html

Question edited for clarity. Question moved from Cars and Trucks. Put it together and run a bucket of balls through it. If it holds, you are fine. If not, spares are readily available. https://www.google.com/search?q=jugs+pitching+machine+parts ..

Fuse is in control ..Hard to get to I cut the section of the box out to get to fuse figured its going to blow often i was cleaning the wheel with a wet sponge when my fuse blew first week.

Time to get a new one.

Get a new motor.

Check for a loose belt.

There can be two possible reasons for this to occur. The first would be that the pitching machine might need more power than that which is available at home, or the machine might be working for a long time and may have got heated up.

Take off the cover and make sure the wire is connected to the knob and check the wire maybe it's exposed an not working properly

What's wrong with it need more info

I think it's 70 mph not positive but pretty sure

Look for stripped wires that could be your problem if you find any tape them up with electrical tape

Are you using the right size fuse I would call jugs and ask them what fuse it takes you could also have a wire that's exposed and touching something metal look for that too

Pretty sure you can take it to a tire shop and get that done

Hi Miguel, Sorry I don't have its control panel diagram, but I think this will help you.

1 1/4 pipe from home depot 24 inches long 30 degree bend 4 inched down

You most likely need to use medium grade sandpaper and use it one the tires. They need to be sanded down in order for the machine to shoot the balls out.

it it something to do with the wiring

Just had this happen on my machine. Opened up the control box and found center disc capcitor was loose from cold solder joint. However we also found the hot lead for the motor at the wiring block on the circuit board had a cracked solder joint. Simply reheated with solder iron and applied little extra solder and it working again.

pull off the wheel and run the machine. you will be able to see if the hub is out off balance. if it spins true the you have a rim or tire out. this can be fixed by having a tire shop balance it for you or call Jugs and get a complete replacement,tire and rim ,shipped mounted and balanced.
it is very unlikely that the motor shaft is damaged unless it was droped trying to load it into a truck.
it most like;y is the tire and rim that is out

It could possibly be one of the bearings starting to go, is the machine well used or new?