i-mate Computers & Internet - Recent Questions, Troubleshooting & Support


sorry but FIXYA can suggest no FIX

i-mate SP5m... | Answered on Nov 27, 2018


Prep Time:45 minInactive Prep Time:24 hr 0 minCook Time:1 hr 0 min Level:Intermediate Serves:10 (8-ounce) jars Ingredients
  • 1 3/4 pounds oranges, 4 to 5 medium
  • 1 lemon, zest finely grated and juiced
  • 6 cups water
  • 3 pounds plus 12 ounces sugar
  • Special Equipment: 10 (8-ounce) canning jars with rings and lids, funnel, tongs, ladle, and 12-quart pot
Directions Wash the oranges and lemon thoroughly. Cut the oranges into 1/8-inch slices using a mandolin, removing the seeds as you go. Stack the orange slices and cut them into quarters. Place the oranges into an 8-quart stainless steel pot. Add the lemon zest and juice and the water to the pot, set over high heat and bring to a boil, approximately 10 minutes. Once boiling, reduce the heat to maintain a rapid simmer and cook, stirring frequently, for 40 minutes or until the fruit is very soft.


While the fruit is cooking, fill a large pot (at least 12-quart) 3/4 full with water, set over high heat and bring to a boil. Place 10 (8-ounce) jars and rings, canning funnel, ladle, and tongs into the boiling water and make sure the water covers the jars by at least an inch. Boil for 10 minutes. Turn off the heat, add the lids and leave everything in the pot until the marmalade is ready.
Meanwhile, place a small plate in the freezer. Increase the heat under the orange mixture to return to full boil. Add the sugar and stir the mixture continually, until it reaches 222 to 223 degrees F on a deep-fry or candy thermometer, and darkens in color, approximately 15 to 20 minutes. You may need to adjust the heat in order to prevent boil over. Test the readiness of the marmalade by placing a teaspoon of the mixture onto the chilled plate and allowing it to sit for 30 seconds. Tilt the plate. The mixture should be a soft gel that moves slightly. If mixture is thin and runs easily, it is not ready.
Remove jars from the water and drain on a clean towel. Place a canning funnel onto the top of 1 of the jars and ladle in the marmalade just to below the bottom of the threads of the jar. Repeat until all of the mixture has been used. The amount of marmalade may vary by 1 to 2 jars. Wipe the rims and threads of the jars with a moist paper towel and top each with a lid.


Place a ring on each jar and tighten.


Return the jars to the pot with boiling water, being certain that they don't touch the bottom of the pot or each other. (If you don't have a jar rack, try a round cake rack, or metal mesh basket. Even a folded kitchen towel on the pot bottom will do in a pinch.) Add additional water if necessary to cover the jars by at least an inch. Boil for 10 minutes. Using canning tongs, carefully remove the jars from the water, place in a cool dry place and allow to sit at room temperature for at least 24 hours before opening. Once open, store in the refrigerator. Unopened marmalade will last for up to 6 months.

i-mate JAM... | Answered on Oct 26, 2018


That is a spam site. You have Malware.

If you have been updating the phones ROM, jailbreaking it, you have indeed broken it and you need a new phone.

/run this

A quick looks says it is running windows? See link at the bottom

This firmware looks REALLY bad news!

mate SP3i ROM Update Version Google Search

Malwarebytes for Windows Phone

malwarebytes for windows phone Google Search

i-mate SP3i... | Answered on Feb 12, 2018


no not as far as i know, when u go in to clear storage it has in CAPITALS you will loose everything!!

i-mate K-jam... | Answered on Jan 17, 2018


could be a hacker attempt to get control of your phone
search the net for forums on that antivirus and be sure of it before you download

i-mate Smartflip... | Answered on Nov 12, 2017


That phone is 12 years old and is no longer made. Parts are not available for it any longer.

i-mate SP5m... | Answered on Aug 07, 2017


hi thanks for using fixya!!

Please check the Bluetooth Settings, then select Mode, you should tick the "Make this device visible to other devices".

Then, select BEAM, then tick "Receive all incoming beams" to enable you to receive datas via bluetooth.

Then, make sure you have enough spaces to your internal memory and external SD card.

Hope this will help, let me know if you need further assistance.

Don't forget to rate me with my simple solution. Thanks!

i-mate JAQ3... | Answered on Jan 13, 2017


hi thanks for using fixya!

Please follow the instructions below:

1. Tap Start Menu
2. Tap Settings Menu
3. Tap to got to Connections Menu
4. Tap Beam, and tick the "Receive all incoming beams", then close it
5. Go to the Bluetooth, you must add new device, make sure that your bluetooth is turned on and the other device must be turned on and visible for you to search it.
6. And there you go, just follow the next steps from your pda and you will be able to send and receive datas via bluetooth.

If you need further assistance, let me know!

Don't forget to rate me positively! thanks!

i-mate SP3i... | Answered on Dec 17, 2016

Not finding what you are looking for?
i-mate Logo

1,325 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top i-mate Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Are you an i-mate Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...