Hoover Vacuums - Page 8 - Recent Questions, Troubleshooting & Support

i think you have pulled the cable end spade terminals off the connectors on the side of the cable drum.

Hoover U6630-900... | Answered on Jan 11, 2018

feel free to look it up like we would. non repair questions take a back seat here at fixya.

Hoover Vacuums | Answered on Jan 05, 2018

more than likely the motor has burnt up and they are not repairable , made as throw away units

Hoover Vacuums | Answered on Jan 05, 2018

The hose between your solutions tank and the sprayer is probably clogged. If you can hear the sprayer noise, and get no spray, you will have to get some solvent and use a syringe to clean the line. Remember each time you use it, you should pass two tanks of fresh water through it to clean it so it won't be clogged for your next use.

Hoover Vacuums | Answered on Jan 02, 2018

Check for a clog , the vacuum will shut off after a few mins or so.

Hoover U5227-930... | Answered on Jan 02, 2018

Hello, Kathy -

If you have not yet checked your owner's manual; the Troubleshooting section, I suggest you do.

If you do not have the manual, you can download a PDF (Adobe Reader) version here:

This is the link to the Troubleshooting section in the manual:

I hope you made sure the dirty water tank was empty and that the filter screen is clean.

Hoover Vacuums | Answered on Jan 02, 2018

I had the same problem with a hoover windtunnel 6200 - u5477-900. I removed the flexible hose from top of the plastic tube running vertically along the right side of the back of the vacuum. When I used a flashlight to look into the plastic tube, I could see a clog at the bottom, where the flexible hose curved frontwards towards the brushes. I then removed the 2 screws holding the vertical plastic tube to the vacuum. When I disconnected the plastic tube from the flexible hose at the bottom, I found a clog of dirt and dog hair. After removing the clog and reassembling, the clean / dirty light now moves back and forth from red to green.

Hoover U6437-900... | Answered on Jan 02, 2018

The schematics of your model show two belts. Which belt are you looking for?

Hoover Vacuums | Answered on Dec 30, 2017

Okay. I read these posts and decided to take the advice of checking the hose.
I had cleaned all filters, checked all hose (as-is) and did belt checks, etc.
The indicator was always showing red and it would shut down after about 5 minutes.
It ended up being a clog that I discovered after taking the hose completely off and seeing a clump right where the hose detaches. I began swinging the hose round and round and sure enough, more cat hair clumpls shot out. Big clumps.
So, you literally need to check every inch of hose to find the culprit.
After that, my indicator stayed green and it works like a charm.
Best wishes, Mike D

Hoover UH70120... | Answered on Dec 29, 2017

Not finding what you are looking for?
Hoover Logo

6,931 questions posted

Ask a Question

Usually answered in minutes!

Top Hoover Vacuums Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18424 Answers

Jim Parker
Jim Parker

Level 3 Expert

1041 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1474 Answers

Are you a Hoover Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides