GE Dishwashers - Page 8 - Recent Questions, Troubleshooting & Support
GE DishWasher starts/drains, but no water pumped for cleaning
-You mean not completely pump out. After it's done Some water still inside right...?
-Mostly the breather cap is clogged or is locate little too low. Check it out and clean see what happen, and make sure it stay up right. not horizontal.
-Where is the breather cap..? Most installer install under the counter be hide the sink. 1 drain tube from the washer to it. And one from the breather to the sink or disposal. Possibly the line is clogged with food waste as well.
GE 24 in....
on Dec 21, 2017
Sounds like your control knob is broken or misaligned.....
take the knob off and check the shaft is not split...it should be "D"shaped and will only go on one way....if it has split you obviously have to purchase a new one.
GE 24 in....
on Dec 17, 2017
My. GE dishwasher is showing E8 code. What does it mean?
means that the unit thinks the water coming into it isn't hot enough. It can be reset, but here is the way to avoid this problem. Run the hot water in the sink until it comes out hot. Then the unit shouldn't give this error.
All dishwashers require at least water of 140 degrees or higher
on Dec 16, 2017
Not finding what you are looking for?