Flotec Garden - Recent Questions, Troubleshooting & Support
The switch has failed on
Did you note to where the 5 wires were attached to the old switch? Does the switch resemble the other less a terminal? No instructions with the new switch?
Pressure fluctuates
There must be a hairline crack to where it is only noticeable when the pump starts to run creating a vacuum.
Water pump not running
Hi have you removed the pump from the well and tested if it will run without going via the presure switch. It could be that the pump is blocked. If it is blocked and has been for a while it may well have burnt out the pump. How deep is your well and how far from the bottom of the well is the pump. The pump should be positioned a good distance from the bottom of the well to prevent any silt getting into the pump to block it. I have a 110 meter deep well and the water level is 38 meters below ground. I have the pump at 50 meters below ground. I have only changed the pump once in 10 years.
I hope this helps
Steve
Wiring diagram
??? THIS PUMP COMES COMPLETE WITH A THREE PRONG GROUNDED PLUG ON IT'S END , NOT SURE WHAT YOU MEAN BY "WIRING DIAGRAM" IT JUST PLUGS IN LIKE ANY OTHER APPLIANCE DOES
I need instructions of Melnor 304F timer for watering
From the Melnor 304f actual instructions:
Use 9V alkaline batter only! Flashing lighs indicate that the battery is low and needs to be replaced.
1) To start: Turn Dial to Off position and press ENTER
2) Set Time: set the current time and press ENTER
3) Start Time: set the time to start the first irrigation cycle and press ENTER.
4) Frequency: Set the frequency of the irrigation cycle e.g. twice a day = 12h and press entere.
5) Duration: Set the duration of the first irrigation cycle and press ENTER.
-- to change the duration
Turn the dial to the new duration and press ENTER
--to turn the water on manually
Turn dial to ON position.. The water will turn off automatically after 30 minutes.
-- to turn the water OFF
Turn the dial to the OFF position
Do NOT press ENTER when dial is in OFF position, otherwise the unit will clear the program, and you have to Reprogram the unit following the steps 2 through 5.
How to install a sprinkler system ?
Sprinklers installation, especially
pop up sprinkler installation is not simple generally.I tried installing it in agricultural land as per the advice of my friend.He also assisted me.But afterwards i had to call a professional to complete the installation.But i think for a garden we can do the installation our own.
Not finding what you are looking for?