Dyson Vacuums - Page 2 - Recent Questions, Troubleshooting & Support


You might need to replace the filters

Dyson Vacuums | Answered on Apr 10, 2018


it Might be time to replace the filters

Dyson Vacuums | Answered on Apr 10, 2018


Remove the filter and turn it on. If it will run ok without the filter in it you may need new filters.

Dyson Vacuums | Answered on Apr 10, 2018


Call them, explain your problem and probably they will send you replacement part, at least they will describe what part is malfunctioning, and you can purchase on amazon or something, here: Amazon com Dyson DC23 parts I hope this was helpful. Have a nice day

Dyson Stowaway... | Answered on Apr 09, 2018


You might need new filters

Dyson Vacuums | Answered on Apr 09, 2018


It could be a bad electrical connection, a bad brush bar motor, or a bad switch. You will have to test all these areas to try to locate the problem.

Dyson Vacuums | Answered on Apr 08, 2018


The filter probably needs replaced. It may also have a clog.

Dyson Vacuums | Answered on Apr 08, 2018


The brush bar motor or one of the switches may be defective. If the brush is not spinning it will not pick up anything from carpet leading many to think it has no suction. Feel for suction down by the brush bar. If you have no suction it may have a clog or need new filters. Make sure the changeover valve that switches suction from floor to tools is working properly.

Dyson Vacuums | Answered on Apr 07, 2018


Pull the handle and hose out to access the screws from the back you need to remove and then release the tabs to allow the cover to come off.

Dyson Vacuums | Answered on Apr 07, 2018


I have a similar problem and want to check the switches...the last release is not apparent...appreciate some help...edw@nebulax.cm

Dyson DC18 all... | Answered on Apr 06, 2018


The belt could be jumping on the cogs of the pulley and brush roll if the belt cogs are worn. I would start by replacing the belt

Dyson Vacuums | Answered on Apr 04, 2018


if it started after you cleaned the filters, it is because when you smack the filter that is in the ball like they tell you to, it pushes the gasket in so air can sneak past it. take it back out and pull the rubber gasket away from the filter so there is about 1/16-1/8" away all the way around, then put it back in. it will seal it and stop.

Dyson DC25 All... | Answered on Apr 04, 2018


Fire smell may be electric shorting out in your motor.

Dyson Vacuums | Answered on Apr 01, 2018

Not finding what you are looking for?
Dyson Logo

9,862 questions posted

Ask a Question

Usually answered in minutes!

Top Dyson Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18424 Answers

Samyfam
Samyfam

Level 3 Expert

379 Answers

Are you a Dyson Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...