Dometic Refrigerators - Recent Questions, Troubleshooting & Support

If ur fuse keeps blowing check ur power inverter. Sounds like its throwing more than 12 at it. Does it work in lp mode?

Dometic... | Answered on Jun 13, 2019

That fridge has 2 elements. A 12v and mains 240v/120v. Sounds like the mains element or the fuse has blown. The fuse box is in behind the fridge at the bottom. Follow the power cord to the box. There should be 3 fuses. Check them all. Using a multimeter, check the readings of both elements. Google " Dometic Service manual DM2652 pdf" and page 11 should help you.

Dometic... | Answered on Jun 12, 2019

Could be control board, could be breaker. You need to look on line for your ice maker and look for parts.

Dometic... | Answered on Jun 06, 2019

If voltage to ignitor bad ignitor if not sparking if no voltage to ignitor bad control board

Dometic... | Answered on Apr 30, 2019

possible heater element bad if on electric if on LP check burner tube possibly overheating if blockage if ok bad control board or low 12 voltage to board

Dometic... | Answered on Apr 30, 2019

move temp sensor down inside right side

Dometic RM2652... | Answered on Apr 07, 2019

Light rear burner on stove, turn to high. Light other rear burner, turn to high. Flame height / spread should not have changed. Light front burner, watch rear, put on high. If flame on rear changes, you have a problem with has pressure on your propane system. Perhaps regulator, perhaps out of propane.

If flames stay same, turn off stove. Go to back of fridge, make sure shutoff has valve is open fully. Close and reopen. Check operation. What color is flame? If yellow, you have a blockage in air inlet of burner assembly. It will need to be pulled and checked, or problem with burner itself. If blue, but still small, take your coach to t.v. service and ask for a propane diagnostic with concentration of measurements at fridge. Might still have blockage though.

Dometic... | Answered on Feb 03, 2019

No model #. For electronic / dsi models.
Check your 12volts first. Use a good quality meter, measure across terminals on relay board. Should be greater than 12v, especially if converter is plugged in. Otherwise, erratic operation can result. If voltage good, contact dometic for potential service issues regarding controls wiring. There are 2 models so far off top od my head.

For models that are manual operation.
Your mode switch is on its way out or shaft has started to slip and handle / pointer does not line up with mode properly. Verify handle position, test mode switch. Both of these tests are in the manual.

Dometic... | Answered on Feb 03, 2019

Try looking on side of the chimney / flue for a rewritable thermal fuse. Will have two wires coming out of it, reset button between them. Press button to reset. If still inop, use a test light and probe across the wires. Clip onto one and probe the other. If the reset button was pressed, and test probe light is on, then you have a bad thermal fuse.

If the thermal fuse resets, take a hard look at why it may have tripped. Operating off level, operating in high temps, blocked ventilation, leaking cooling unit.

Dometic... | Answered on Feb 03, 2019

Since I don't know what does work I am kind of shooting in the dark.
Does the ac heater get hot ?
The spark ignitor is part of the control board. But won't work?
I assume that you have a user manual but I am including a link to download one.

Note that there are three fuses. B (12V control) and C (120V Heater) on the control board and a thermofuse L located on the stack.
If L is good and everything else is good there should be 12VDC on J1 and at Fuse B

Dometic RM2620... | Answered on Jan 09, 2019

Look at the back of your fridge by temoving lower vent / avross panel on outdide. Find the 12v power wires that are likely coming up from floor of compartmentn. They should go to a small terminal block. Make sure they are tight here, on both sides of the block.

Look closely in this area for a fuse holder, probably valued at 25 amps. Check this fuse, replace as necessary. If blown, can be caused by dc heater failing or converter may have surged while running on the shoreline.

Find the AC outlet where fridge is plugged into. See if it has a reset button on it, otherwise check bath and kitxhen outlets for an ourlet that resets the ground fault / earth leakage function. If this is tripped, may have been a surge when operaring on shoreline or generarator or a wiring problem could be present.

You may also have a bad mode switch, especially if frisge is gerting both 12vdc and ac power to it. Its not unusual for propane to continue to be able to operate since that is the preferred mode for most rv / caravan refrigerators.

Service Manual:

Dometic... | Answered on Jan 06, 2019

Not finding what you are looking for?
Dometic Logo

2,456 questions posted

Ask a Question

Usually answered in minutes!

Top Dometic Refrigerators Experts

Sheldon Dedek

Level 3 Expert

909 Answers

Paul G
Paul G

Level 2 Expert

156 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Dometic Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides