At this web link you will find the data sheet as well as several user guides.
be sure the cable you have matches the emulation you wish to user.
contact the vendor or Honeywell for information.
be sure codabar is set to on, min length at lease 3, same code out.
The turbo wedge menus are printed in codabar.
http://www.honeywellaidc.com/Site.aspx/na/en/product_center/product_support/?category=5&product=140
at this web link you can find information on the turbo wedge.
www.compseemfg.com
all menus are covered in the manual ..
to set the terminal ID
scan enter terminal id
scan 2 digits form the options page to set the terminal type .
scan exit terminal selections .
most of the menus run in this same sequence .
for example to set the AUX port on a turbo 1 to RS232
Scan Enter General II
Scan Auxiliary Port selection
Scan a 0 (zero) form the digit colum on the Options page
Scan Exit Gerneral II