Char-Broil Grilling - Popular Questions, Answers, Tips & Manuals


the flames should be blue and the burners clean. check gas pressure and the air mixture dampers. touch air will give you the same effect. if the burners are clean, it is the mixture. as far as the slots in the bottom. i have not seen that. but i work on commercial ranges.

Char-Broil... | 195 views | 0 helpful votes


DUH the food one might think

Char-Broil... | 238 views | 0 helpful votes


You need to try Googling (Char-Broil)(4754512)(manual) to get correct instructions.

Char-Broil... | 245 views | 1 helpful votes


You need to contact Charbroil with your order number and the model of your grill. I've found them to be quite helpful.

Char-Broil... | 207 views | 0 helpful votes


Probably bad thermometer. Double check with a cheap oven thermometer. Warranty?

Char-Broil... | 81 views | 0 helpful votes


Gauge bad on old tank? Says half full, but actually empty?

Char-Broil... | 182 views | 0 helpful votes


make sure the propaine is not to low and the burner orafice is clean

Char-Broil... | 122 views | 0 helpful votes


Turn off propane. Disconnect propane tank from barbecue. Open burner valves for about 20 seconds. Close valves. Reattach propane tank. Slowly open propane tank valve. Turn on burner and ignite

Char-Broil... | 103 views | 0 helpful votes


Should be a leaver just above the wheel witch should just push down

Char-Broil... | 63 views | 0 helpful votes


Check the regulator. It's probably bad.

Char-Broil... | 40 views | 0 helpful votes


Igniter is combined in the valve of grill so the best way is change the new one. or cross flame from other burner.

Char-Broil... | 89 views | 0 helpful votes


Contact manufacturer for new igniter, new igniter should come with instructions for replacement. It should be fairly simple, disconnect two wires and retaining nut and then replace with new igniter, connect wires and screw on retaining nut.

Char-Broil... | 108 views | 0 helpful votes


Not enough information. If we assume the other two control valves are turned on, are the orifices clogged, are the valves leaking, are there safety valves attached the the natural gas line to detect leaks?

look down inside the valve stem to see if there is a tiny screw. this is an adjustment for the valve to allow more or less gas flow. if the valve was damaged or tampered with this could generate better flow. if the appliance went a long time without being used the valves could be clogged. remove the orifices and blow out the orifice and the valve with the orifice removed.

Char-Broil... | 53 views | 0 helpful votes


Most BBQ makers know that their ignition system will be the first thing to break so they give your a small match holder. The loop holds a short match so you can lower it down to light the burners manually, the chain just connects it to the grill so you don't lose it.

Char-Broil... | 158 views | 0 helpful votes

Not finding what you are looking for?
Char-Broil Logo

621 questions posted

Ask a Question

Usually answered in minutes!

Top Char-Broil Grilling Experts

paulcarew

Level 3 Expert

2179 Answers

Dean Gruber

Level 2 Expert

109 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Are you a Char-Broil Grilling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...