Washing Machines - Page 5 - Recent Questions, Troubleshooting & Support

bad pump on bottom back or board see if voltage to pump motor

Splendide RV... | Answered 15 hours ago

check vent for obstruction if ok bad heater element

Splendide 2000S... | Answered 15 hours ago

is water on if ok check water solenoid

Splendide... | Answered 15 hours ago

On washing machine error code e7_4 display and stop
Not working

Washing Machines | Answered 19 hours ago

E9 means the waterlevel sensor is defective or the pipe connected to it is faulty.

Washing Machines | Answered 20 hours ago

If the unit is not leveled properly, it will not drain properly. The front of the unit cannot be higher than the back If not properly leveled, the water can flow back into the machine. If this is the cause of the problem,

Bosch Washing... | Answered 22 hours ago

Yup, LE is the door latch. Seems like at some point the solenoid gets too weak to push the switch that tells the washer the latch is really closed and it cuts power to the latch and won't operate.

The door latch is fairly easy to repair. I've done it twice and I'm just an intermediate DIYer. The latches seem to fail every 3-4 years. You pull the rubber ring and the metal ring from around the door, then undo those two screws you can see around the latch. Then unplug. Then reverse. Unlike many instruction videos for other ASKO models, you do not need to pull the front panel off to do this. Just the rubber ring and huge retaining ring that holds it in place.

The confusion right now is finding the parts because no one SEEMS to have them in stock, but they are easy to get, if you don't bother with google to find them, because you won't find them there. Sub Zero has exclusive rights to distribute Asko parts in the US now. So you have to go through them. If you use google you will find "out of stock" and "discontinued" on the listings of everyone else who used to be allowed to sell them. The official distributors aren't google friendly, I guess.

If you are in New England, you can get parts from Certified Appliance Parts if you are in the Mid Atlantic you have to go through Mid-Atlantic Parts Distributors. If you are elsewhere, search for "sub zero parts" and your state. The right place should come up.

You need ASKO item #3619046410 Door latch It cost me $43.3091b107-adb1-46a6-88c7-2854451f7a6f.png

Asko WL6532XXL... | Answered 23 hours ago

Motor brushes could be worn, these don't smell of burning when they start to ware out.

Washing Machines | Answered Yesterday

Did you have a small part of clothing sticking out the door? Water can leak past the door seal on this case. Other than that, run the machine empty u ntill you find the leak location.

Kenmore 24832... | Answered Yesterday

Have you checked the motor brushes? If they are badly worn the motor will struggle to turn

Washing Machines | Answered Yesterday

Google make and model number (look on the back of the machine) and get the manual.
Take it apart and clean it out.

Bosch Washing... | Answered Yesterday

Not finding what you are looking for?
Washing Machines Logo

247,599 questions posted

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

77194 Answers

Brad Brown

Level 3 Expert

16404 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides