Heavy Machinery - Page 9 - Recent Questions, Troubleshooting & Support

they go between some of the blades to get the proper width .

Dewalt DW7670... | Answered on Nov 27, 2015

If you can get the make and model number of the unit you can go on the internet and manufacturer web site and get the specifications for unit. Will include motor specs also.

Heavy Machinery | Answered on Nov 23, 2015

Chippers sometimes bite off more than they can chew but there also could be a malfunction of the drive mechanism.

Heavy Machinery | Answered on Nov 21, 2015

Often the cause is something inedible jammed inside but there could be a problem with drive clutch.

Heavy Machinery | Answered on Nov 21, 2015

The fuel tank cap vent hole could be plugged.

Vermeer 2006... | Answered on Oct 30, 2015

The first thing I would do is replace the spark plug. It could have a cracked insulator. Another problem could be that the fuel tank vent is plugged. Check the fuel tank cap to see if the vent hole is plugged.

Heavy Machinery | Answered on Oct 30, 2015

The first thing I would do is remove the spark plug.

Vermeer BC625... | Answered on Oct 30, 2015

Check for cracks in the fuel line.

Heavy Machinery | Answered on Oct 30, 2015

My first idea is that the engine was shut off before the chipper or the shredder had not finished. First remove the spark plug. Next remove the covers on the chipper area and the shredder area. Now remove all material from both areas.Replace all covers, put the sparkplug back and try it.

Craftsman... | Answered on Oct 30, 2015

Just found some parts for my Troybilt Gardenway chipper-vac Model 47279 on this website http://www.partsandservice.com/bin/ipl.cgi
I would think they might have something for your machine.

Troy-Bilt... | Answered on Oct 19, 2015

SORRY but you have to contact the manufacturer who by the way you did not mention in question .

Heavy Machinery | Answered on Oct 17, 2015

your seal on the shaft defective,

Troy-Bilt... | Answered on Oct 02, 2015

go to Toro commercial service center. They are expencsive. I have the same set up as your workman for fertilizing and spraying. Where are you located? I am in Holland,, Michigan

Toro Workman... | Answered on Sep 26, 2015

have you greased and oiled the machine, changed the oil. it sounds like the oil. the oil pump start to fail, causing metal to metal reaction,

Toro 2007 Dingo... | Answered on Sep 16, 2015

It's adjusted too tight or the belt is too small

Troy-Bilt... | Answered on Sep 14, 2015

Manuals - KO4BB.com

KO4BB's Manuals Repository. Announcement: FTP uploads are enabled. Check UploadInstructions for details. Upload Instructions · Copyright · Manuals and ..

Heavy Machinery | Answered on Sep 11, 2015

Not finding what you are looking for?
Heavy Machinery Logo

1,800 questions posted

Ask a Question

Usually answered in minutes!

Top Heavy Machinery Experts

Bill Boyd

Level 3 Expert

45552 Answers

Daryl Gleaton

Level 3 Expert

708 Answers

Tom Chichester

Level 3 Expert

36408 Answers

Are you a Heavy Machinery Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides