Heavy Machinery - Page 6 - Recent Questions, Troubleshooting & Support

go to ytmag.com & get into the MF forum. Experts there will quickly help you.

Heavy Machinery | Answered on Apr 23, 2017

probably on a plate attached to the tow frame

Heavy Machinery | Answered on Apr 04, 2017

Under the lowest pan sump left side on bottom.

Heavy Machinery | Answered on Feb 03, 2017

i have had this problem happen to me. On the engine look for a push rod that is in sync with the brake. When the clutch is engaged it pushes a rob into the transmission to disengage the drive gears, if the rod or linkage is stuck the fork truck will will not move because the clutch is stuck in. I had to pull the linkage apart right at the trans and grease it went working back to normal, this should be a part that gets greased on a PM

Heavy Machinery | Answered on Jan 23, 2017

1 Layer = 12 drums
1 pallet = 3 layers
1 drum = 20 kg
1 pallet = 40 kg

3 layer w/pallet = (12 * 3 * 20) + 40
= 720 + 40
3 layer w/pallet = 760 kg

Heavy Machinery | Answered on Jan 04, 2017

You can prime the engine by taking cover off the air filter and removing the air filter. Cover attached by one screw. Spray starter fluid behind the white-plastic guard. Before attempting to start you must put back filter and cover. If not, the air/fuel mix will not be correct and the engine will quickly die out.

Troy-Bilt Heavy... | Answered on Nov 11, 2016

call cummins service center for the correct oil to use in cummins engines
the details will be in the user manual or service manual for the machine

Vermeer BC1000XL | Answered on Oct 29, 2016

In the most new there is an auto- power-off inside both or one of the carbon brushes that it will stop when its time, but when you hearing a difference in motor rpm or a strange noise then it can be neccesary.

Heavy Machinery | Answered on Oct 12, 2016

Contact the manufacturers support center.

Heavy Machinery | Answered on Oct 06, 2016

The codes don't have a letter in front of them?

Heavy Machinery | Answered on Oct 06, 2016

Troy Bilt Part Number 1762636

Troy-Bilt... | Answered on Oct 06, 2016

BC1000XL Manual

Vermeer BC1000XL | Uploaded on Oct 04, 2016

check the back of pulley there might be 4 holes they will possibly be pusher holes to loosen the pulley from the shaft .

Troy-Bilt Heavy... | Answered on Sep 05, 2016

Not finding what you are looking for?
Heavy Machinery Logo

1,824 questions posted

Ask a Question

Usually answered in minutes!

Top Heavy Machinery Experts

Bill Boyd

Level 3 Expert

45531 Answers

Daryl Gleaton

Level 3 Expert

708 Answers

Tom Chichester

Level 3 Expert

36394 Answers

Are you a Heavy Machinery Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides