Heavy Machinery - Page 4 - Recent Questions, Troubleshooting & Support


Go To ditchwitch.com parts, manual.

Power Equipment... | Answered on Oct 19, 2017


The switch must be the choke control. Try holding open manually. You may have to remove the choke solenoid (electric choke) If closed it cannot get air through the venturi which is what pulls the gas through the carburator jets.

Briggs &... | Answered on Oct 19, 2017


If you want to solve your problem, click on the link I attached
Best Manuals

Heavy Machinery | Answered on Oct 14, 2017


Repair your vehicle right away. Just click on the link I attached Best Manuals

Power Equipment... | Answered on Oct 14, 2017


Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
1990 Geo prizm

Heavy Machinery | Answered on Oct 14, 2017


Depends on tractor model, E is electrical 23 is for relay or fuse . Check start relay and fuse panel.

Heavy Machinery | Answered on Oct 02, 2017


Check the starter and solenoid.

Vermeer Bc625a... | Answered on Sep 27, 2017


Remove the spark plug, take it to the small engine shop and they can get you what you need.
They will have the oil also. 10w-30 will be OK.

Heavy Machinery | Answered on Sep 26, 2017


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Heavy Machinery | Answered on Sep 25, 2017


I'm sure you will get the solution of your problem, just check the link I attach
Best Manuals

Heavy Machinery | Answered on Sep 25, 2017


You just go to the link I attached I'm sure you will get the solution of your problem
Best Manuals

Heavy Machinery | Answered on Sep 25, 2017


Guessing you are talking V-belt tension.
V-belt adjustment rule of thumb is to tighten so that the belt will twist 90 degrees in the middle of the belt.
Make sure your belt isn't glazed and that your pulley are aligned. Place a straight edge from pulley to pulley and look for a gap on one side or the other of the smaller pulley and adjust so that the straight edge touches the face of both pulleys.
The manufacturer has very good customer service according to what is out there.
Here's their site -


Mackissic Chippers

Heavy Machinery | Answered on Sep 24, 2017


Give this a try -
manualagent.com/troy-bilt/cs-4325-chipper-shredder/owners-manual

Troy Heavy... | Answered on Sep 13, 2017


Your carburetor is gummed up from old gas.
Remove and clean out the various jets.

Mtd Heavy... | Answered on Sep 09, 2017

Not finding what you are looking for?
Heavy Machinery Logo

1,967 questions posted

Ask a Question

Usually answered in minutes!

Top Heavy Machinery Experts

Bill Boyd

Level 3 Expert

46605 Answers

Tom Chichester

Level 3 Expert

37910 Answers

ray gallant

Level 3 Expert

47630 Answers

Are you a Heavy Machinery Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...