Heavy Machinery - Page 3 - Recent Questions, Troubleshooting & Support


Dear,
The hindging point of the hydraulic cylinder and the steering can be the cause....also the "kingpin" of the stub axle get jammed . Make it free, this will work perfectly, Also lubricate the hindge point daily... this problem can be solved.
with regards and reply.

Heavy Machinery | Answered on Jun 19, 2018


Use your computer search engine, type in "Bolens 47018 owner's manual " it will bring up sites to get manual.

Heavy Machinery | Answered on Jun 17, 2018


There should have been a separate manual for the Brigg's and Stratton engine that accompanied the user manual. That engine manual addresses oil and gas. I also suspect that the model number is 4265. At any rate, if there is no dip stick, it is likely you want the oil to the top of the fill hole. You can check by phone or chat the support for the chipper shredder if this has not assisted you. Click the link below.

http://www.troybilt.com/webapp/wcs/stores/servlet/DisplayOwnersManualList?storeId=10001&catalogId=14102&langId=-1&logoCode=02&modelNumber=CR4265&serialNumber=

Troy Heavy... | Answered on Jun 16, 2018


ozarkshermit If you want a copy of mine I can e-mail it to you. I have a Bolens Owner/operator manual for the model 47018- 8 HP bluehue hotmail com

Mtd Heavy... | Answered on Jun 12, 2018


filters operate at low pressure and as the pump is capable of pressures in excess of 2,000psi it would indicate that there is a problem in the lines from the pump to the filters to what ever is being run
Again filters are normally on the suction line so that any foreign particles and dirt do not get into the close workings of the pump
Whatever way the system is set up, the reason is high pressure caused by a blockage somewhere or a jammed pressure relief valve

Heavy Machinery | Answered on May 29, 2018

Not finding what you are looking for?
Heavy Machinery Logo

2,090 questions posted

Ask a Question

Usually answered in minutes!

Top Heavy Machinery Experts

Bill Boyd

Level 3 Expert

51146 Answers

Daryl Gleaton

Level 3 Expert

742 Answers

Tom Chichester

Level 3 Expert

44896 Answers

Are you a Heavy Machinery Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...