Health & Beauty - Page 7 - Recent Questions, Troubleshooting & Support
What is ear wax and do I need to get rid of it?
Ear wax
always gets a really bad press but it's actually there to help the protect the
ear. It's produced in the ear canal and then slowly makes its way to the
opening. It should come out naturally by itself or with gentle daily washing.
When you use ear buds you just push the wax deeper into the ear and ultimately
that increases the risk of infection.
Hi our mini pro makes a loud buzzing noise and vibrates excessively on 3 rd speed any ideas Grahame
Grahame, this is posted in cars and trucks and the only mini in a name I encounter there is a Cooper. Otherwise, I see Mini Pro associated with DRONES. It you are having a problem with a drone, it could be due to a loose component or the motor. Your best shot would be to check with a relevant service center nearest you. You would need to google the whole name of the device plus service center, very likely. I just am not sure what the device is. Originally, I thought it was a question about a scooter! Maybe repost with information identifying the item.
Where can i buy blades for 2 speed us 9098
Are these blades broken or just blunt? Can you comment below with a photo of the blades you have? Some of the blades on these machines can actually be re-sharpened. A fine file or a small sharpening stone can put an edge back on them. A little bit of time and effort and you don't have to go parts hunting for a few more years.
Omron nebulizer ne-u22 will not stay on. Power indicator light quickly blinks once when on/off pressed but no response.
Some people write that it needs replacing new batteries. To some extent they are right. But when batteries are weak it gives signal showing red led light on left side. But even if the green light blinks after pressing ON button and does not stay ON. It means that there is problem with it's MESH CAP(Part number NE-U22-4). Either you need to replace it ,if it is completely rusted/damaged due to its prolonged use/improper cleaning etc ,
Or needs proper cleaning.So before taking decision for it's replacement,one should try to clean MESH CAP properly. Try to clean it for 2-5mins in boiling water,remove it,rinse it and dry it naturally without wiping or touching the mesh. I have been following this procedure when I face such problem for NO MIST from my Micro air Omron Nebuliser model NE-U22, when green light does not STAYON. Just do this , mostly one need not to replace it's MESH CAP lifetime. I am using this nebuliser since 2009 and it works very fine. Just needs regular cleaning of MESH CAP, mouth piece, medication jar,cap/cover etc.,
Not finding what you are looking for?