Bionaire Dryers - Popular Questions, Answers, Tips & Manuals

Contact Bionaire directly and request the color code.

Bionaire Dryers | 94 views | 0 helpful votes

These run very small motors with low "starting torque" If the fan hasn't been run for a long time, its possible that it has jammed up or got tight from just sitting there. Being careful, turn on the fan and spin it in its usual direction by hand, it should start running. If you cannot spin by hand, it may have seized up which will require you to strip and lube the motor. If you manage to get the fan spinning , let it run on high fan speed for an hour or so, it should free up and then be OK again. A small spray of WD40, CRC or similar spray can lube on the fan shaft where it disappears into the motor may assist.

Bionaire Dryers | 518 views | 0 helpful votes

Might need to be cleaned..If there are any small children around it they like to see what can fit into holes fan might have a lot of lint and or small coin blocking it from turning also check water tank it won't work if it's full.

Bionaire Tower... | 507 views | 0 helpful votes

Go to walmart and get a new one

Bionaire... | 1,097 views | 1 helpful votes

The easiest way to to use pressurized air. Buy a can or use compressed air.

Bionaire... | 1,166 views | 0 helpful votes

i bought a bionaire fan today and was looking at the manual the fuse is located at the end of the cord where it plugs into wall you have to open the square piece holding the prongs there you will see it good luck

Bionaire BW2300... | 201 views | 0 helpful votes

The remote for Bionaire® 20" Ceramic Mini-Tower Heater with LCD Control uses BUTTON cells (Disc type, 3 volt, CR2025)..
Open the remote as shown in page 4

Bionaire... | 929 views | 0 helpful votes

There are no user serviceable parts in that fan.

Bionaire BT40... | 463 views | 0 helpful votes

go to
God bless you

Bionaire Dryers | 70 views | 0 helpful votes

wow... you must have got it really wet ! but if that is why it is not working now, then set it out in the sun for a few hours, or put it in front of another fan. hope this helps. post if it does. There are other problems it could be and I may be able to help with that as well. first things first. good luck. Tim

Bionaire BW2300... | 273 views | 0 helpful votes

I found my own solution for fixing my fan, I took the cover off of the fan by removing the base, and the three screws that hold the cover on, I cold start the fan by turning it on and forcing the blades to turn, But that was the only way it would work. What I found was at the top of the shaft that goes through the fan there is a rubber cap that holds grease it is held on with two screws , The grease in the cup was hard and wouldn't let the fan move freely, So I cleaned out the old grease and put in some new grease that I had here it is grease used for my pool pump motors to keep the seals soft so this grease wont get hard. I put the fan back together and it is working fine. I hope that this works for you. Denis K.

Bionaire BT45RC... | 708 views | 1 helpful votes

Possible that the capacitor is weak and so does not power the coils to turn rotor. you will need to check the free movement of the blades, is no use some oil to free the rotor blades, if the blades are free then check the continuity of the coils specially if they are heating up , if so check the capacitor.

Bionaire BT40... | 1,524 views | 0 helpful votes

Not finding what you are looking for?
Bionaire Logo

126 questions posted

Ask a Question

Usually answered in minutes!

Top Bionaire Dryers Experts

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1691 Answers

Brad Brown

Level 3 Expert

18067 Answers


Level 3 Expert

5292 Answers

Are you a Bionaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides