Baumatic Washing Machines - Page 2 - Recent Questions, Troubleshooting & Support

It just pulls off, it takes quite allot of force.

something has gotten into the drain that has not got out causing it to rub against tub

Which model do you have? What happened that led up to the error? If you are sure there is no problem or problem has been fixed, try the reset button. Reset Buttons for Washing Machines

there is a dead short in the machine get in a service technician or an accredited electrician to check it out it may be at the wall plug or faulty cord to the machine

Maybe you overload your washing machine. Minimize your washing machine usage to avoid stopping during the spin.

Try this site, I use it a lot to troubleshoot. repair clinic dot com

IS THERE A DETACHABLE PANEL AT TOP? IS THERE A CREVICE NEAT THE TOP? IF NOT U MAY HAVE TO REMOVE THE WHOLE CABINET? IS IT TOP LOAD OR FRONT LOAD? HERE ARE SOME PICS THAT MAY HELP

I'm not a washing machine repairman, but this sounds suspiciously like a worn-out or defective timer. Only guessing here, but perhaps (USD) $50 in parts plus the cost of the service call. This model seems to have a fairly good reputation and considering the cost of washing machines, I'd probably be inclined to have it professionally serviced. It doesn't sound like something you can fix yourself. Also, most newer washers will not spin if the load of wet clothing is not balanced (evenly distributed) - of course you have likely checked this. Good luck

hi, you need to empty the filter, ours does the same all too often. The filter is located bottom right of the machine at floor level, which is rather daft for an integrated applicance; we have to remove a whole length of plinth to empty ours. Be warned, a lot of gunge and water will come out so have towels at the ready, especially if you have a laminated floor. Turn the white slot with a a 10p piece......and empty. Not the most pleasant of jobs, but effective. Good luck!

I have had this same problem - you need to clean the drain as a starting point. You can do this by removing the front panel at the bottom of the machine (you will need a Torx head screwdriver) then gently unscrewing the filter on the bottom right hand corner. Keep a tray underneath though - as water will flood out as you remove the filter! If the filter is full of fluff, you should be able to fix the machine by cleaning it out and then putting it back in.