Apex Digital Audio Players & Recorders - Recent Questions, Troubleshooting & Support
APEX DT250A digital box died
The Problem more often than not is with one or two of the electrolytic capacitors on the power board. They can be bought at Radio Shack for about $1.50 or less. You can tell if the Cap is blown by looking at the top.. it should be flat and have a x stamped in it.. if the top is cracked or "domed" the cap is bad. I just fixed one today for an employee. If you're not comfortable doing board level repairs, I suggest finding a friend. The repair took me a total of about 15 min. The Bad Cap was a 470uf 25v, but radio shack had a 35v one.. works just fine.
HOW DO I GET AN ANSWER FROM YOU PEOPLE
by asking the right question. If you ask a vague question you have a good chance of getting a vague answer .
as previously vaguely expained you have to do an auto scan
and let it complete.
This is based on your tv being connected to an antenna and being the model Apex Digital Apex LD4088 40 Class LCD HDTV - 1080p, 1920 x 1080, 16:9, 60Hz, 1800:1
You have to press menu button on your remote control when you see the message you saw on the tv screen.about Auto Scan. Then use the left and right arrows to select tv mode. Press the down arrow to select Air/Cable. Press the left or right arrow to select Air if antenna and Cable if it is a cable service. Once you have selected Air or Cable press the down arrow to select auto scan . If air then press right arrow on the remote (if cable then press enter on the remote)
This is explained on page 18 of the tv user manual
http://data.manualslib.com/pdf/1/84/8384-apex_digital/ld4088.pdf?0fa28d37b4d5ca4a9f59538bc95467d9
Comcast remote codes for apex digital dt502
Brand: Apex Digital
Most likely code: 10765
Others to try:
10748, 10879, 10767, 10890, 11991, 10889
To program your remote:
- Turn on your TV
- Using the code list, find the first five digit code that is listed next to the name brand of the TV that is to be programmed
- On the Comcast remote, press and release the TV key
- On the Comcast remote, press and hold the SETUP key until the TV mode key blinks twice then release the SETUP key
- On the Comcast remote, enter the first listed five digit code
Note: If this number is entered correctly and is an accepted TV code, the TV mode key will blink twice. If the code is entered incorrectly or is not an accepted TV code, the TV mode key displays one long blink and exits programming mode
- Aim the remote control at the TV and press the POWER key once
- The TV should turn OFF - if it did not turn off, repeat steps 1-6 with the next TV code listed, until a working code is found
Tv channel scan
If you are using cable TV the channels could all be scrambled requiring a cable decoder box.
Not finding what you are looking for?