...yamaha dtr 125 engine back together step by step instructions would be nice as i dont have much knowledge thankyou how do u open power valve on a dtr 125 h.plate Hi hope this helps 1. place enging ...
i need to find out how to put on a cv joint boot 2001 kodiak the easiest way is to remove the half shaft and do it on a bench they are a bit tricky
...125 will not shift into first gear Hello, I have a 2005 ttr125 that was shifting fine. We replaced the clutch plates and springs, oil and air filter. After we did this, I'm having trouble getting it ...
...125 and it is fouling plugs This can be caused by all sorts of things.There is no real order of probability so I'll just list them.Your oil/fuel ratio could be rich depending on what oil you use,your ...
yamaha yz 125 i chucked a br8eg plug init and a new air filter but the problem just wont go away Two things could be at fault here. First - it's a good possibility you would benefit from a new top end
...125 top end back together my question was what is the torque specs on the head and on the jug G'day. The torque specs for the 8mm head bolts is 18ft/lbs.the jug?(cylinder or barrell) is just ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions