Questions & Answers for: yamaha receiver power rx v463

...yamaha receiver rx-v480 keeps turning off when i turn it on check your speakers cables, connections. check for possible cable short. If seem ok, remove all speakers, turn the unit on and see if still ...

...yamaha rx-v463? anyone? It is 30376. The trick to discovering, is to turn the receiver off, first. Then it will power on when you input mute/select 30376. Then you can program the DirecTV remote to ...

Yamaha sound receiver amplifier RX-V463 check the standby power supply first and then the main power supply.also check the output transistors and fuses your problem is in one of those points, normally

How do I reset Yamaha Rx-v463 which does not power up? check the tiny power button next to the big one. if that doesnt do it, its in need of repair. or if youre capable, you can check the fuses inside

...receiver. Since the RX-V463's amplifiers don't drive the sub directly, and it supplies the sub's amp with only a Line Level signal, the impedance of the sub is irrelevant. ...

I cant get my receiver to power up. The fuse that is visable is still good. What should I do now use a multitester to prove that fuse is not open, if it is ok there some problem with its power supply.

...yamaha, natural Sound Av receiver RX-V483, every time that i start the unit it will shut down after 5 seconds. thank you very much It indicates an output load problem, dis-connect the speaker wires ...

...Yamaha RX-v463 receiver, the tv screen dims to a darker image repetitively. When the tv is disconnected from the receiver, the problem does not exist. Any suggestions? How connected? Audio, video or ...

...yamaha receiver RX V463 Disconnect power cord to your receiver and wait about 3 to 5 minutes before do this step If you can find on the back side of your receiver use to have a small button recess ...

...Yamaha receiver RX V463 is immediately turning itself off after I try and turn it on? (both with remote and on the receiver itself) Power it On without speakers connected.If it powers up, reconnect ...