WYSE Website but you have to setup a FTP server to get it installed. An easier way that seemed to work for us so far is go into Control Panel -> System -> Memory Tab. Adjust the memory slider so about
jumper settings to bypass password i bought a this terminal, and the bios is password protected. i need to clear the password Default passsword is Fireport (note: case sensitive) To get set password ...
...setup and connect, it is a far from complete solution, though. I would suggest you google upgrading the winterm firmware using FTP, the older firmware is poor and slow. Otherwise, these are great ...
...wyse 1200Le thin client and this error came - OUT of Frequency. what could cause this problem? The display settings are not valid with the monitor. Either you are using a new monitor or you have ...
Question about Winterm S30 Network Terminal
...Wyse winterm S30 terminal? Hi, Can someone help me because I don't know how to add a network printer on a S30 terminal? Thanks The S30 terminal has the CE 5.0 operating system loaded as default. So ...
Question about WINTERM 1200LE Network Terminal
...wyse terminal frequency.Its overrange, i can't see anything when i power it up.Can smbd tell me how to reset factory default with power on. This is caused by the terminals default display resolution ...
...Wyse S10 terminal back to it's factory settings without setting up another "parallel unit" and trying to duplicate the keystrokes on the terminal without a screen?? This is caused by the terminals ...
what is setup password you can dawnload it from the manufacture websit.Just send a mail to request for password with your products no. Default Password is "Fireport". You can reset terminal to factory
...were no instruction in the Dell 190 monitors for this configuration to a V10LE. Any help would be greatly appreciated. Have you enabled dual-head mode on the WinTerm (Start-System Setup-Dual
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions