...WORKS. KEEPS SAYING ITS BUSY AND THEN WILL NOT PRINT AN ID CARD. ANY SUGGESTION? The is usually resolved by replacing the head lift motor or sensor. hello my problem always the ribbon is broken, wath ...
Question about KIT-C3530N MFP LASER CLR P/S/C/F USB ENET 1200X600 128MB Printer
...The plastic shutter in the ID is fully or partially covering the toner sensor window. Resolution: Move the cover upward to allow for the sensor to become fully exposed prior to reinstalling the
Question about Aficio 2022 All-In-One Laser Printer
ID sensor defective ? TD sensor abnormal ? Drum does not turn ? Development roller does not turn ? Poor connection of the PCU drum unit Clean connector of TD sensor and Try Change the development unit
...works for part of day then go's back into sc-405 code again. that is a transfer belt error. transfer belt not moving away from the drum during ID sensor pattern check.possible main motor/ drive ...
...printer in for repair. A good source of free tech. support for the Brady ID Pal is Graphic Products. They even help people who are not their customers, They also do Brady printer cleaning and some ...
Printer has ceased working. It makes a noise and flahes red. how do I clear a paper jam? open all cover and clean all sensor by air blower properly It may seem like an obvious solution, but have you ...
...ID sensor. This sensor reads the density of toner on the Drum. Probably its dirty (on the worst case is broken). I advise you to clean it to see if it works. If doesn't work i advise to call your ...
...id i am very thankful for this in life This is a sensor problem, the sensor is insite the printer and it needs to be disassamblied to change, you can try to press the front cover from left site and ...
ID Card Printers Identity Solutions ). 3. The ribbon-sensor has failed (printer cannot see / sense the ribbon's presence). If we can help further, just reach out to us! Safe-Card ID Services Charlotte
...look at the opening from the right you can see a black sensor unit facing inward towards drum clean its inner side with a dry cloth and put back everything it is the id sensor, machine should work ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions