Questions & Answers for: wont turn on Vacuums

Ad

Question about DC17 Animal Bagless Upright Cyclonic Vacuum

1 Answer

...wont turn the brush wont turn most likely the belt is broken. Bad news regarding all Dyson's. You can't replace just the belt your self. You have to purchase a new belt assembly which includes the ...

Ad

Question about DC14 Animal Bagless Upright Cyclonic Vacuum

1 Answer

...ANIMAL AND THE BELT WONT TURN. ALL I DID WAS CLEAN THE STRINGS OFF THE BAR AND PULLED THE BAR OUT. NOW IT WONT TURN WHEN I PUT IT BACK IN The bar is not atached to the drive belt or the belt is ...

Ad

Question about 6594 PowerForce Bagless Upright Vacuum

2 Answers

...wont turn on. My Bissell 6596 was working fine and I turned it off to empty the canister. Now it wont turn on. The belt is intact and the brush turns freely in both directions. What could be wrong? ...

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

2 Answers

...wont turn even after cleaning hoover steamvac f5914-900 agitator brushes wont turn even after cleaning filter. the brushes will not turn even wen the switch is turned on the gear that the brushes fit ...

Question about DC17 Animal Bagless Upright Cyclonic Vacuum

1 Answer

...WONT STAY RUNNING. TURN DC 17 UPRIGHT BRUSH MOTOR WONT STAY RUNNING. TURN ON AND IT RUNS FOR 5 - 8 SECONDS AND SHUTS OFF. WAIT 5 SECONDS AND CAN TURN ON AGAIN BUT SHUTS BACK OFF. have a look at the ...

Question about DC17 Animal Bagless Upright Cyclonic Vacuum

2 Answers

...wont turn on fairly new . Will not turn on. What could be wrong with it? tried several outlets and nothing happens. I have the same problem. Fairly new machine, only been used a handful of times and ...

Question about DC14 All Floors Upright Vacuum Cleaner

1 Answer

...wont turn on, Was cutting in and out and now wont turn on at all. Have cleaned all the filters and checked for loose wiring and all ok. Is there a fuse??? My Dyson DC14 will not run. It will turn on ...

Question about DC14 All Floors Upright Vacuum Cleaner

1 Answer

...wont turn...belt is good ..will turn by hand but motor wont turn it.. Check that the belt is not too slack and that the brush bearings are not too tight, or that some lint or thread is caught around ...

...wont turn on Took the power head apart now wont turn on but turns freely by hand no bearing noise but wont work adjusted the carbon brushes still wont work were did I go wrong ??? im stuck Have you ...

Question about Ball DC24 Bagless Upright Vacuum

1 Answer

...wont turn My brush bar wont turn. It is not blocked or clogged. I have taken it out. The drive does not seem to work. Once you put it back together recline the vacuum as normal use and turn it on. If ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...