Questions & Answers for: UPM wiring Kitchen Ranges

HAVING TROUBLE INSTALLING A GE DIGITAL TIMER SWITCH HAVE A HOT WIRE LOAD WIRE AND NEUTRAL I CONNECT HOW THE DIAGRAM SHOWS AND GET POWER TO THE UNIT BUT WHEN IT IS SWITCHED THERE IS NO POWER TO THE ...

GE digital timer. Instructions say to: 1) connect Hot/live wire of main to black wire of timer, 2) connect neutral (White) wires together, 3) connect Hot/live wire of load to red from timer. 4) green ...

I have two 110V lines (two wire) coming into a box. I have 2 loads out (two wire). 1 load is always on and one is on a switch. All four whites are wire-nutted together. How do I incorporate this timer

blink on and off but will not stay on. I tried reprogramming, but same result. Help? It sounds like wiring is wrong. If you have GE Tork Intermatic UPM Woods Brinks Hagar Pass-n-Seymour Stanley Westek

...Timer black wires. - If lights blink on-and-off, then you connected white wire incorrectly, review wiring shown above. If your box does not have neutral wires or bare ground wire as described above, ...

my switch does not have a whtie wire in it what do I do with the white wire from the timer? Connect the timer white wire to bare ground wire.Open following link to read ...

LIGHTS FLASHING WITH ETW350 If this is new installation, the wiring is incorrect.If this is old installation, try resetting timer.Copy following link to see how to wire single-pole ...

...inside Copy following link to identify GE 15164 timer and download possible manual and see wiring for 240Volt ...

...override. Installed by home improvement contractor, not electrician, but has done much lighting wiring in my home. If this is an electromechanical timer and the dial will not rotate, you can be ...

UPM ETW350 Hi, I have only 2 wires, black and white, could you explain me how I connect them. black is hot white is neutral should be bare or green for ground