Questions & Answers for: wires starter 1989 gmc

STARTER WILL NOT CRANK OR CLICK INSTALLED NEW STARTER,BATTERY & CABLES....STARTER WILL CRANK W/REMOTE SWITCH CONECTED TO STARTER... I CHECKED THE RED WIRER ON THE SILINOID FOR POWER WITH A TEST LIGHT,

...1989 GMC Safari starter I just dismount the damaged one and buy the new one but I can't remember the wiring. I do know the positive coming from the batery but I have 2 united thin cables that I don't ...

...1989 replacement starter am replacing the starter on my old 1989 GMC sierra truck. The old starter had only one little terminal screw .This new replacement starter has two small terminal screws a "S" ...

starter put it in and still nothing. checked all my grounds and wires and they all match up. i even bypassed the neutral saftey switch by running a cable straight from the s terminal on the starter to

...wires from the starter one set at a time and mark them so you don't get them mixed up. Remove the two bolts (5/8" I think) and pull the starter out. Replace the solenoid also. STARTER LOCATED UNDER ...

...wires to each injector? When I check the hot wire to ground then I do have 12 volts? It seems the negative conductor is open? The negative signal comes from the ECM according to the fuel flow needed ...

where does starter wiring go 89 gmc k1500 See if this helps you out --- https://www.youtube.com/watch?v=LM4YNSlgVDc

Where do wires hook up on 1989 GMC sierra starter Try this --- https://www.youtube.com/watch?v=LM4YNSlgVDc

...starter to a 1989 gmc safari pick up Disconnect battery remove the 2 bolts lower it down remove the wires from solenoid paying attention to colors and where they go on new one then repeat backward to ...

...starter and battery, but the problem may be as simple as the battery cable connections. Many people do not remove the wires and clean them or on a GMC this old you should replace the cables as well. ...