Questions & Answers for: wire rover ride

...rover P38 No cutting just add a wire to get your pump to run nornal Connect a wire to the orange cable on the compressor pump and the other end to ground that will stop the heat switch working inside ...

what wire do i cut to bypass the immobilises on what wire do i cut to bypass the immobilises on my rover 420 no wire can be cut to over ride immobilizer

i have discovery 98 , when i go for a ride about 20 kilometer , and i park the engine will not start( no sound of starter ) again , it will take around 2 hours to run again , the temperature in the ...

...ride the immobiliser which was installed after I purchased the Landy. The agency which installed it cannot help me. Which wire do I cut, the red one or the blue one and where the heck are they? I am ...

...rover and i noticed while i was driving that my right front end was leaning lower than my left front side and a message came on saying that the air suspension is inactive. Help what is it??? Hi, ...

I need a wiring diagram for a rover rancher 1755 ride on mower Go to www.outdoorking.com

...Rover Discovery 1 misfiring. No blue smoke at all, checked turbo, it's fine. Is it the HT leads? Turbo has been checked and is fine. It's not the timing belt either. Engine lacks power but idles ...

2001 land rover discovery 2 rear suspension stuck at lowest point won't go into normal height Check ride height switch could be broken wire or bad connector or lastly bad switch BTW is by rear axle

...rover ranger ride on mower has been sitting for 7 or 8 years it has no spark even though i have changed the spark plug have you any areas ? regards Bob won't go has no spark although have changed ...

...ride. Bags went down to stop bumps my Range Rover hse 06 will not raise up my compressor comes on for 2 seconds and goes off truck still does ride I change all the fuses and relay even bought a new ...