Questions & Answers for: wire mower rectifier

...wire was attached had broken near its base. I replaced it with a new rectifier (#72256-03) from B&D, The mower ran for awhile, but soon stopped again. Yep, the same terminal on the new rectifier ...

...mower.) The rectifier is a flat plate with 4 posts that attach the electric wiring inside. You will need a flathead screwdriver to remove the four screws holding down the cover on your mower. on top ...

...mower/bandd/index.phpThings to know: One wire goes through the on/ off switch button. This wire will read 1 unless you push the button. If you get a reading of zero for this wire when the button is ...

...rectifier unit. Before replacing it though, inspect the wiring to make sure you don't have a broken wire. Unplug and replug the connectors to make sure it isn't just dirt or a loose connection to it. ...

mower from said that the wire got a little hot. this is a craftsman 2 18hp 6 speed with 44" cut. Thanks Chuck If the wire comes from under the flywheel it is most likely the stator lead that goes

...be low and very high for each diode leg in each direction of test leads (4 diodes if it has 4 wires) test each leg both ways, or get testmeter with diode ...

The mower will turn over, but i have no spark in the plugs. Could the problem be a bad regulator rectifier? check your 3 safety switches,pull the black wire off of the coil and try to start it

what to check for? mower will start and run till battery go's dead... charging system isn't working. maybe a wire fell off the rectifier.

...is rectifier located on an unidentified mower? If it has on it is located on the engine housing and will normally have three wires going to it. It is also known as the voltage

...rectifier My black and decker lawn mower started tripping the house switch after cutting some high grass. I read it was probably the bridge rectifier so got one and replaced it. My old one did not ...