Question about JJW9330D Electric Single Oven
...wire to one leg of the hot. the oven came on briefly and then cut off. i could smell electrical burning. after disconnecting the wiring and discovering i had wired it wrong i wired it correctly but ...
...fuse still pops even after i remove the wiring for the stat. The only time it wont pop is if the red wire is off the transformer. People tell me that the board its gone and that a new one is around ...
...wire on the fuse holder somewhere in the middle and strip off a short length of insulation. Next apply some solder to the now exposed wires on each of the ends of the fuse holder. Then ...
...top of the board . Two wires on a connector blue and brown. The round black fuse thing is right below the brown wire. Not sure were to get a replacement fuse, will have to unsolder it from the
...wire between R & G put door back on and turn on power. Blower motor should run, if it blows the fuse then you have a direct short between R & G at the board. Do this with R and W(heat) and R ...
...wire back into the TV. The area where the TV wire is soldered inside the TV is the power supply board. There is fuse on the board. So this means you have to disassemble the TV.... Regards. ...
...wire is soldered inside the TV is the power supply board. There is fuse on the board. So this means you have to disassemble the microwave.... Note that microwave store a lot of current, so unplug it ...
Question about GMS90703BXA Heater
...wire "may" have just blown a fuse on the control board if it was supply voltage for the sensor. The control circuit voltage is a nominal 24 volts, often tapped off from a winding on the cooling ...
Question about GMS90703BXA Heater
...fuse. You can take each thermostat wire off the control board and use a ohm meter and test to ground, should not have any resistance. Another way is turn off power take each wire off the board, then ...
...the wire fixed first!! You could, first, disconnect all low voltage from the board (taking picture first) and replace fuse and cycle power. If still no leds, likely have a bad board ALSO. Best
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions