Questions & Answers for: Chevrolet Monte Carlo wire detached

need to know the torque specs for a rear wheel bearing on a 1999 monte carlo? Hub & Bearing 3.8L engineRemoval & InstallationTo Remove: Hub and bearing assembly mounting All W-body cars are ...

Ad

Question about 1999 Monte Carlo

1 Answer

I need help findind my starter on my 1995 monte carlo its 3.4 v6 engine could you please help me with a diagram showing where abouts it is? Thank you Disconnect the negative battery cable. Remove the ...

Ad

Question about 2005 Monte Carlo

2 Answers

...wiring diagram? 2005 Chevrolet Monte Carlo Car Radio Wiring Chart Car Radio Battery Constant 12v+ Wire: Orange Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched ...

Question about 1995 Monte Carlo

1 Answer

...to 89 inch lbs. (10 Nm). Attach both lower oil cooler hoses to the radiator. Fasten the engine wire harness and retainers. Carefully lower the vehicle. Attach the oil cooler pipes to the

Question about 1995 Monte Carlo

1 Answer

...to ignition including the whole fuse box/engine compartment/passenger side/so, i RAN A SECONDARY WIRE TO THE BIG WIRE ON THE ALT. FROM THE BATTERY.THEN IT STARTED CHARGING.NEXT WHEN THE IGN. & ...

Question about 2004 Monte Carlo

2 Answers

plug wires will not come off With ether the 3.4 or 3.8 v6 it will be difficult to remove the plug wires. I would ask you to get a tool to help but if you can't. Try to pull the wire from the bottom, ...

where is the starter located in a 1986 Monte Carlo? need to remove and replace the starter on my 1986 Monte Carlo. Hi there:Check thie REMOVAL & INSTALLATION procedure...Starter removal on some ...

Question about 2001 Monte Carlo

1 Answer

brake line diagram I have my passenger rear brake line detached. Any easier steps for someone with limited car experience on how to fix. Pictures help. remove rubber hose replace with new then bleed ...

...detached from rear window? I have had the window replaced 3 times & it keeps happening. I would check to make sure there is enough slack in the wire to alow for flex and if there is plenty try a ...

...should go off at this point if working properly. The following is the wiring so you can trace the wires to find a possible short of the wiring. It shouldn't be a short though if working and is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...