...to the same colors to the becket burner and the two brown wires are connected the the same positions on the capacitor all just as the original blower motor. Do you think it might be the relay ...
...cage assembly is removed, cleaned, new motor and capacitor installed and then wired back in. Goodman has a five year warranty program on many of it's units, verify before spending money on a ...
...capacitor, hook the solid brown wire on the dual cap., and wire nut the brown wire with the white stripe, this will work as well. the voltages are as follows * Black wires------->Contactor T 1. * ...
...capacitor wires and the nuetral wire. There are two wire sets that you can switch that can do this if your blower motor is equipped. You might experience some airflow problems, probably a lack of ...
Goodman air handler blower motor wiring I replaced the blower motor and wheel because of a vibration. The motor has two brown wires that go to the capacitor and three others. A black, red, and purple.
blower motor wont work good transformer and good capacitor Hello, bypass the board by jumping the L1 and high speed motor wire, if the blower works, bad board. If the blower does not work bad blower
capacitor is the can with two or three wires coming from it. Shut off the power to the unit and remove the blower panel. Check to see if the motor turns free and is not noisy. Next see if the motor is
Question about GMS90703BXA Heater
goodman furnace model GMS8 ciculator blower wont stay on gas fires and runs but high limit trip because of no air from blower any ideas bad motor or control module blower runs thirty seconds or so and
Question about GMS90703BXA Heater
...wire that goes back to the 240 side of the transformer and run it straight to the speed tap from the motor that's connected to the relay. I'll help you with the relay when you get when but this will ...
Question about GMS90703BXA Heater
wire colors on the control schematic (electrical drawing) to see if the wires are connected properly. If your motor has been wired improperly you may have already damaged the windings in the motor and
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions