Question about 1999 Town & Country
...whistling" whether totally stopped or braki Depending on how hard youre pushing on the pedal there is a whistle noise that happens and the noise is coming from the engine bay around the firewall. The ...
...brake petal is depressed. the whistling sound slowly whines down after the engine is off. Brake fluid is ok and had the rear brakes changes 3 months ago. A/C, and vents make no difference in sound.. ...
...brake pedal went to the floor,pumped a few times its Ok.No leakes @ wheel cyl.,fluid was fine.Whats wrong? IF you pumped the pedal and brakes were retored, then you probably were low on fluid, and an ...
Question about 1995 Wrangler
...whistling noise when accelerator pedal not down After engine warms up/usually freeway driving, I release my foot from accelerate pedal and whistling noise comes from front drivers side under hood. ...
Question about 2007 Tundra
...brake pads and there is a grinding noise Here is what I have found out. I have an 2008 Toyota Tundra 5.7 4x4, and I changed the rear brakes and rotors. No noise prior to service. After installing new ...
...Brake pedal fade? http://technoanswers.blogspot.in/2012/04/2008-toyota-tacoma-abs-causes-brake.html--------- Toyota Camry: Premature ABS Actuation? ...
...noise in front when turning right, This could be most anything but you can check: Condition of the front brakes...overworn or a brake pad broken loose, a bad front bearing, out of alignment so tires ...
brake pedal have vivration i expect the brake discs are worn/warped and /or the pads , only way to tell is to strip down the front wheels etc , check also for any movement in the wheel bearing's , top
Question about 2004 Tundra
...Hi Dalton your toyota problem is the brake booster (servo) , I don't know if you have noticed that, when you press the brake pedal you can hear the air leaks , is like a whistling noise. Good ...
Question about 2005 Tundra
...brake job, I'm certain all air out of lines. I now have o pedal an no brakes. I also re built master cylinder ? HELP Try bleeding the air out of the master cylinder crack the lines at the master ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions