Whirlpool Hi Timon9, On the DRY-Miser (Automatic) setting, the timer is not moving, but if I use the Timed setting, it moves as it should. I'm getting flame and heat..so that does not seem to be an ...
whirlpool dryer GEW9200LL1 doesn't start I can turn the control on and make any setting adjustments but when I push start it beeps at me and blinks the dry time. When I check the diagnostic test it ...
Question about GGQ8831L Gas Dryer
Whirlpool Gas Dryer, LGR5636EQ2, timer not moving on Auto (DryMis When I set the timer on the * (Dry Miser, Auto setting), the dryer runs forever because the timer doesnt move. The flame appears to ...
whirlpool gas dryer not working, think the timer is bad. If the timer knob is manually held (jiggled) on the 20 minuted "timed drying" setting the dryer runs and will heat up, it won;t work at any ...
Question about LAB2700ML Pedestal Drawer for Duet Washers & Dryers
...whirlpool duet electronic dryer I will put a medium size load in my 4 yr old duet front loading dryer for 70 minutes and the clothes are still damp... If it is heating , check for a kinked or stopped ...
...Whirlpool LER7646AWO dryer. When I set the dial for the dry setting (like the time it will run), the dryer starts and then immediately buzzes and stops as though it were at the end of the cycle. It ...
...dry miser Hello, What the automatic dry miser is, is a sensor that measure how dry the clothes are and will adjust the time its going to take to dry the clothes throughout the entire cycle. If at the ...
dryer does not shut off after automatic setting is selected . The dryer is a whirlpool model # LGT 8858 AW0 and has an electronic dry-miser. replace timer/control board
dry-miser doesn't stop Replace your Timer knob. The contacts inside your timer that controls the motor has burned(arced) together. Not a hard part to place. BUT VERY HIGH VOLTAGE, so unplug. Or call a
Question about GGW9868K Gas Dryer
...Whirlpool Dryer LER7646EQO. I need to know how to diagnose the automatic dry-miser feature. Update: The dryer is working fine now. I think I just didn't wait long enough for it to do its thing. I ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions