Question about Duet GHW9150P Front Load Washer
stuck. cannot open, turn off, etc. My machine was running and I had to hit the pause button for a few minutes. I went back to turn the machine back on to finish the cycle and now the clock just blinks
Question about Duet 7.0 Cu. Ft. Super Capacity Plus Gas Dryer
...Whirlpool DUET Front Loader) not drying The dryer is not drying correctly or completely!!! The vent is totally clear and the gas thermostat is set to High. The unit was inspected by a qualified ...
...whirlpool_duet_kenmore If your clothes are stuck inside and you still cannot get them out because the door will not unlock, you will have to use the manual release to open the door. The next link ...
Question about Duet GHW9150P Front Load Washer
...stuck at 1 minute, so I hit pause/cancel and "INT" appeared on screen. I tried to restart, tried to cancel, tried to open door. Nothing is working. Unplug machine, wait 2 minutes and re-plug. This ...
...whirlpool duet washer GH9150, water was shut off and now it is stuck in cycle and will not stop FH = (No water detected entering machine or pressure switch trip not detected) If after 30 seconds the ...
Question about Duet GHW9150P Front Load Washer
duet washer is stuck at 1 minute - I think my son opened the door with 1 minute left and it will not reset itself. It is not locked, but I have tried holding that button down to restart it, I've tried
Question about Duet Sport 6.7 Cu. Ft. Gas Dryer
...Whirlpool duet sport dryer gives F02 code. I saw that means a stuck button or faulty connections. I found the bottom half of the start button is stuck in. It still clicks when you push it so I don't ...
Question about Duet Sport 6.7 Cu. Ft. Gas Dryer
...for 2 minutes if error exists replace CCU board Causes: Pump driver failure to activate on CCU. Main Relay stuck on CCU. Relay points welded or open on CCU. Bummer. DUET SERVICE MANUAL AND MORE ...
...whirlpool front load washer Frontload failure code F-1 EEprom error due to: power glitch remedy: unplug washer for 2 minutes if error still exists replace CCU board Causes: Pump driver failure to ...
Question about Duet GHW9150P Front Load Washer
...stuck in agitation cycle and a 45 min load will take about 1 1/2 hours Have you ever unplugged the unit in its current location? Try unplugging it for 10 minutes and plugging it back in to reboot the ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions