Questions & Answers for: wheres knock sensor located 2

...knock sensor for my 01 olds aurora with a 4.0 engine bank 1 sensor 1 will be in exhaust manifold by firewall in the middle. bank 1 sensor 2 will be behind convertor .bank 2 sensor 1 will be in the ...

...knock sensor located on a 1999 mazda millium Hi, my 01 Mill. noc senser was on top of the motor, but under the intake! needless to say it cost alot... had other stuff done so I can't tell what cost ...

Knock Sensor location? Is there a diagram available for a 2001 Nissan Xterra on where the knock sensor is located? V6 3.3L The sensor is located underneath the air intake manifold on top of the engine

...knock sensor? i have a 2003 oldsmobile alero and the first cyclinder went out. i have replaced all the spark plugs and wires. and it is still knocking. so i was told the knock sensor could be bad. ...

...knock sensor located on my 92 Jeep Cherokee 4.0L straight 6 4WD? I don't see the knock sensor on the 4.0L engine. --- COMPONENT LOCATIONS Fig. 1: Electronic engine control component locations - 2.5L ...

where is located the knock sensor of 1990 toyota camry motor 3.0 YOU SHOULD HAVE 2 KNOCK SENSORS ONE ON EACH BANK UNDERNEATH EACH INTAKE MANIFOLD.

...knock sensor located on a 2000 alero All knock sensors are bolted directly to the engine block. they usually have two wires. Some are on the top, bolted to the intake manifold (v6 or V8) others are ...

...knock sensor at on a alero olsnobile 1999 2.4 twin cam From my Mozilla Firefox browser, I typed in, "http://www.yahoo.com." When Yahoo pulls up, just type in, "photo/drawing of 1999 Oldsmobile Alero ...

...that cylinder #1 is located at. Downstream Sensor 2 refers to the oxygen sensor's location which is after the catalytic converter. (as opposed to upstream which means before the catalytic ...

...is the crankshaft sensor on 01 ALERO oldsmobile The crank sensor is located beneath the intake between the starter and oil filter it has one small bolt in it remove the bolt and pull the sensor