chain and the solvents in motor oil which are intended to clean automobile engines will damage your oil pump causing the saw not to dispense enough oil or any oil at all. You should also avoid bargain
...Saw Type 2" (Starter assembly illustrated on the "Handle, Chassis & Bar Assembly" print.) http://www.ordertree.com/modelinfo/PWE/2375LE-Gas-Saw-Type-2/75.2375LE-Gas-Saw-Type-2.1.59.1.html Helpful ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chain are off powerhead Please do the following then reply below with what you find. Starter Handle difficult to pull: 1. Was this saw perhaps operated in a lean condition (metal transfer from the ...
Question about CS310 14" Bar Length Fully Assembled Chain Saw
my saw is only 5 months old and will not start worked fine when i first got it stored it for a few months with no gas in it now it wont start Remove the spark plug and clean the electrode at the end ...
Question about "Chain Saw - 16" Bar, 3 Hp
What causes the chain on my 240E to jump off the chain bar often, the chain tenson is correct. is the bar bent?try and flip it over and see if it falls off the other side if you can see a bend
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions