Questions & Answers for: welder leaking gas

TIG 250/250 Tig 250/250 I tried to used the tig but it seems like there's no gas, chcek all the lines but there's no leaks. Machine was set at DC-, and Med Doing Mild Steel welding Any help would be ...

...welder(Gas Metal Arc Welding). Welding aluminum requires the use of a mig welder, and inert gas called argon. The machine itself cost 500 to a few thousand dollars. I have one in my shop just in case ...

gas is leaking at the trigger This sounds like you need to reapply the gas sealing thread tape to ALL Gas fittings, again. You need to ensure there is a good seal on all screw, or compression fittings

...get a gum that can seal up the leaking area or part. But if it is a metal, you will have to take it to a welder or panel beater so that they can help weld or seal up the leaking line tube. Good

...is powering up fan is on and can here gas coming through and wire is feeding make sure your work-piece has a proper ground. and maybe check your gas connection. no leaks. maybe turn gas

...welder generator 301g trailblazer Gas runs out of carb drain when running if it is the float bowl drain leaking, close the drain. If it is the vent, clean float bowl and needle and check level. Next ...

i have aweld pak 155that quitsending gas throughthewhip lots of gas attheplug end when i unplug the whip when plug it back in no gas at tip changed the 2 o rings didn't help iblew air through the whip

gas should pulse smoothly with a little force. I'm not sure how to describe it, but it should be more than just a trickle, in other works. If your pump seems to be doing ok, and all of your fuel lines

...leaking? short of spraying soapy water on it to see where its coming from I am stuck. unless its ok to spray water in that area sounds to me that the sealing o-ring or gas block is cracked ? maybe ...

...leaking at the feed rolls I only purchased the welder last week and haven't got to use it yet there is no seal at the feed rollers around the wire as it requires the correct gauge wire and feed hole ...