Questions & Answers for: weld range heating element

...the set point. I shutoff the power to see if that reset the controller but no luck. If it was a welded relay I would expect the burner to stay heated even when I set it to off. Is this a ...

...heating even though the control was in the off position. Any ideas on why this is happening? Sorry, but that's a bad one. If you have a JBP78 as you posted under, the broil heat relay contacts arched ...

...range surface light stays on one heating element started to spark - I removed that heating element and noticed it didn't look like the rest, so I assume it is brokent and I will replace it - however, ...

element does not got off. You do not list a model number, but this condition is generally caused by welded contact points in the electronic control. (requires electronic control replacement

range the heat go's up by it self(from low heat to high heat. Infinite switch, it's not cycling internal contacts are welded together, make sure control it's set on low, if the heat element. stays red

Heating element burned out (literally!) The bottom heating element started glowing bright white (like arc welding) at one spot and was shooting sparks. The spot started moving along the element and ...

heating element will not turn off, a one inch section glows orange. Turned oven off, put it back on clean, broil and off again, no change. You probably just need a new bake element. Many ranges supply

...range then you have a bad heating element. Be careful when removing the heating element as they have a bad tendency of welding themselves to the cooling unit and if your force it loose you could ...

heating element repair the Heating element will not go off even when the oven is off, we have to unplug to go off I am not familiar with this unit but it sounds like the thermostat has failed with ...

...today--no problems before-Range is 9 years old You have a bad broil-element relay on the Electronic Oven Control (EOC) - the contacts have welded shut (closed). You will need to replace the