Code on keypad 4. Press Lock Button on keypad 5. Press Black Pushbutton one time There is a door direction jumper on the control panel. Just move it over! http://www.weiserlock.com/PDFs/install_sheets
...weiser power door lock, I do not have the manual. i dont know how to deleate code lost manual You can change codes as often as you like, for use by babysitters, contractors, etc. You can also reset ...
...code. Lock should retract. Repeat for second code. If both codes are working, replace plastic cover over electronic panel. Position top of cover, then snap bottom of cover into place. User manual is ...
Question about 907 907-15 Satin Nickel Powerbolt Keypad Electronic Deadbolt
...Weiser Company and marketed under both brand names for years, until the company sold off the Kwik-Set brand. These instructions will work for your lock. Hope you find this Very Helpful - Best
Question about 907 907-15 Satin Nickel Smart Code Smart Code Deadbolt with One Tou
...Kwik set both sold and marketed the same lock under their own brand names, as Weiser was the manufacturer, these instructions apply for your lock set. Hope you find this Very Helpful and best
code, but the lock doesn't turn. The batteries are okay. How do I get the door to lock/unlock using the keyless pad? if the batteries are new and good, sounds like a problem with the lock motor..is it
code for the lock, there is a long beep and then nothing...I don't have a key for the lock given we just moved into this house. Is there a way to open the lock without having to call a locksmith (i.e.
setting a new code Go to this link: http://www.weiserlock.com/Support/Faq/50160000000HhhZAAS.aspx Which will show you how to open and change the program code. It's a good time to change the ...
...lock button on the touch pad to set the code. You will hear a two second long beep when your code is accepted. If the unit does not beep, too much time has elapsed between pressing the program button ...
Question about ELECTRONIC DEADBOLT KEYLESS ENTRY DOOR LOCK
...Weiser Powerbolt lock has the Program button either on the top left or lower right hand side of the board (depending on the way the door opens) under the cover. Press the Program button once and then ...
Usually answered in minutes!
208 Questions
160 Questions
140 Questions
126 Questions