Questions & Answers for: wd640

Ad

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

H20 errors on Hotpoint WD640 Get H20 errors while washing or drying. Using Y connector and can confirm water is getting into machine this is normally a water valve problem

Ad

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

hotpoint wd640 replacement motor brushes hi,i have a hotpoint wd640 washer dryer which is 2 years old and has not had any problems yet,but i have been told the brushes in the motor should be replaced ...

Ad

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

Aquarius Hotpoint WD640 is not spinning Machine is not spinning or emptying water out of the drum. pump problems

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

where do i Find the heating element on my wd640 washer dryer I am unable to find a wiring diagram for my hotpoint wd640. The machine is working fine just not drying my clothes. It goes through the ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

wd640 stuck on test hi, i have a wd640 super silent but it al it says is test on display, plz help hold both buttons in until dsiplay clears

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

Hopoint aquarius wd640 will not dry Hopoint aquarius wd640 washer dryer goes through the drying cycle but does not dry check heater for drying programe

Question about Aquarius WD640 Front Load Washer/Dryer

2 Answers

where can I get user instructions for a hotpoint washer dryer Aquarius+WD640 You can get the manual here. ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

have a fault code show on washing machine f-01 hotpoint wd640 Thanks Paul F01 - motor triac on main pcb. check motor connections/brushes etc if not will need new pcb.

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

WD640 Hi, My WD640 is not letting out water. Can this be repaired and if so how? Turn off water supply to inlet valve, and disconnect the hose at the inlet valve.Get a bowl or bucket, and put hose in ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

wd640 problem not pumping out f-05 wd640 problem not pumping out says f-05 Error code means pressure switch jammed on full. Remove lower rear panel of washer Remove large black hose fastened to bottom

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1479 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

Brad Brown

Level 3 Expert

18060 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...