Questions & Answers for: waverunner code

...waverunner shows no bad codes, just 01 the normal code. It doesnt have very many hours on it. Does anyone know whats wrong? what is it idle at? how much? remove your seat check air filter if is black ...

how do I reset the code on a yamaha waverunner How do I reset the code on a 99 yamaha waverunner 1200 ? How do I reset the code on dash board 99 yamaha waverunner 800? How do I see the solution

...waverunner should start. If it does not, hit and hold your mode button till it says CODE on the right gauge again, and enter the same letters in the same order that you stored them, now it should say ...

...relay or the start **** becareful jumping the relay no fuel around air bike out and you have to take off the exhaust manifold to get to the starter How is reset the code on Waverunner XLT 1200? ...

code for a 1999 yamaha 1200 waverunner. Behind front storage container is a wiring harness, locate the single blue connector and disconnect, red light should be on dash now hold mode button down until

reset pass code I forgot my passcode for my wave runner and I don't know how to re set it Contact Yamaha

i got a 1998 yamaha waverunner dont no the code to get it started Call a dealer with the engine number they will have it on a network file

waverunner (1200 XL) with error code E*HST. what does this mean? Please help!!! Warning light flashes and E * HST is displayed. See page 46 of the attached PDF manual (page 2-19) What you are actually

stroke waverunner with check engine light on after 30 min ride, turn off restart and run for 30 min comes on again. Get the fault code read at the dealer or a well equiped repair shop that fixes boats

I bought a 99 gp1200 waverunner with no start code... help!! Probably best to go back to who you bought it from to get the code. Otherwise you will need to visit a dealer and pay them to get a code.