Questions & Answers for: Whirlpool duet no water in tray

...water. We have removed the tray and cleaned it but did not help. I have had three sepaerate service calls and one independant analysis about this problem. For the whirlpool duet washer - this is a ...

...tray. Is water left in the dispenser at the end of the cycle? About two tablespoons of water remaining in the dispenser compartment at the end of the cycle is normal. At the end of the wash cycle, ...

...water (tray is almost full) that stays in the detergent tray. Just recently started, we clean our trays often. Best plan is probably to take the detergent tray right out of the machine, then take it ...

tray is for excess water from condinsation and such most have acess from fron or back most fridg.have a grill in the front take it out then pull pan out or take it out the back check it if water in it

Water leaks out of the detergent tray like it's overflowing. That happened to us when there was a piece of clothing (in this case a sock) that somehow left the drum and got lodged in the tube that ...

...it. Clean the whole area also- I use a dish washing brush to clean the jet to ensure the water goes straight down into the tray rather than squirting all over the place! Hope this helps, Cheers, John ...

...tray is not the answer, it is still worthwhile taking it out and cleaning on a regular basis. In the same way, particularly if you live in a 'hard' water area i.e. lots of calcium, it is well ...

...water should siphon. It is likely to be blocked by 'gunge'- a mix of powder and conditioner. The whole of the tray, particularly this pipe and the bit which fits over it, must be completely clean and ...

...tray with water this will then drain away easily providing its not blocked. Good luck. It is normal to have about a 1/4" worth of water in the bottom of the tray, it's good to have a small amount of ...

water coming out of soap tray and running down the front of the machine Your soap tray and/or inlet is probably blocked with undissolved powder. Remove the tray and clean it. Also clean the inlet tube