bissell flip it and it seems to be leaking water from the dirty water tank whilst cleaning the floor Either the valve asm. on the tank is bad, or the tank is cracked. Throw your Bissell Flip-it in the
Question about 1699 ProHeat Clear View Upright Steam Vacuum
...bissell.com/images/UserGuides/7901_207.pdf Push the foot pad handle release on the left side lay the handle all the way back.Then lift the handle on the center bucket pull out and fill with hot tap ...
Question about 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum
flip it not dispensing detergent liquid not coming out when mopping soap probably dried up and clogge the ports,always run clean warm water through the unit till the soap is cleaned out
Question about 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
...water bissell proheat 2x with microban will not **** up water/solution that is sprayed on for carpet cleaning Try checking the lint filter. It is located in the top clear plastic section (the section ...
Question about 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
...water My bissell 9500 doesn't pick up the water Try checking the lint filter. It is located in the top clear plastic section (the one with the dial to switch from floor to tool use) and is a small (1 ...
Question about 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
...bissell x2 12 amp carpet shampooer the solution and the water went into the carpet, but i don't know how to pick the water up, i beleive i have the proheat version. please help. thanks, shona The ...
Question about 52889 Flip-Ease All-in-One Vacuum and Mop Vacuum
...bissell flip ease it leaks water all over the floor and it says you can store it with water in it. It sounds like you have a faulty gasket and to find if this is the problem you will have to find ...
Question about 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
...need a pin or something small enough to clean out the jets bye sticking pin or paperclip in it . Detegent left in the machine sometimes cloggs the jets.Empty water before you flip the machine
Question about Flip-It Select Hard Floor Cleaner - Volcanic Satin
...water and solution into a bissell f... How do you put water and solution into a bissell flip it? Refer to http://www.bissell.com/searchresults.aspx?searchtext=7340&mode=userguides for the User ...
Question about Flip-It Select Hard Floor Cleaner - Volcanic Satin
...Bissell carpet cleaner turn on? Unplug, and check the end of the hose, tool, and inside the dirt water tank stack and remove any clogs. Let the unit sit unplugged for 30 minutes after removing any ...
Usually answered in minutes!
1,133 Questions
1,137 Questions
870 Questions
836 Questions