...washing machine WM2233H Error code is FE I found this information on the internet. I hope that it helps. " Getting fe code on lg washer. "This means that the washer is overflowing. This is a built in ...
Question about WM2233H Front Load Stacked Washer / Dryer
...washing machine doesn39;t seem to hold the water and just drains out as its filling. Make sure that the outlet of the pipe is at least as high above the floor as the top of the machine. If it is ...
...washing machine stops at spin cycle, doesn39;t seem to be draining properly. If I open front drainage hatch to let water out the machine will start its spin cycle. Happening every wash now and ...
...washing machine over fills with water, ie. the switch to stop filling and start washing doesn39;t go off. I can drain it by setting it to spin. top loading machines comes with a pressire switch to ...
Question about Affinity ATF7000E Front Load Washer
...washing machine washes the clothes, then drains then starts to do a light tumble right and left. it never goes into a rinse cycle. It finally stops and shows an error code E10. I don39;t understand ...
...washing machine starts to add water for about 15 seconds then stops. drain pipe cleaned. Belt is fine. Can hear clicking as though it wants to go through cycle but doesn39;t do anything. Probably ...
Question about Affinity ATF7000E Front Load Washer
...Washing machine wont stop filling, in tub to start washing cycle.What can I do ? Lid off, right side circular pressure switch with black hose attached. Remove end of hose, blow down to make sure not ...
Question about Affinity ATF7000E Front Load Washer
...water solonoid that doesn39;t want to close after the fill cycle has stopped. Number two, if the machine has not started to agitate the clothes that means the timer has not reached that part of the ...
Question about Ultimate Care II LSQ9564J Top Load Washer
...tube is not pinched or broken,the water level switch in the control console is bad. If the machine lets water through when it is in the OFF position,the water valve where the hoses connect are
...washing machine it seems fills water washes then stops at wash it doesn39;t go to rise or spin cycle unless I turn the nob myself I checked the lid it locks that39;s fine, any ideas? Defective ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions