washer will not stop filling and overflows. My very old -but so far dependable-washer will not stop filling with water and overflows. Won't do the wash cycle but will rinse, spin and drain A ...
sensing cycle. After ten times, "3E" Error is displayed, When the motor Is told to stop because of an operating function. no error is shown. Power 81W OFF can clear the motor restriction error. Thanks
sensing cycle. After ten times, "3E" Error is displayed, When the motor Is told to stop because of an operating function. no error is shown. Power 81W OFF can clear the motor restriction error. Thanks
Question about Fisher & Paykel Washer
...level non-stop washer turned on, no water was let in. Washer just go into sensing water level. Any switch the same size will work there fine, It must have the three pins,com, nc, no on the
Question about WTW4950XW Washer
...Washer won't go past the sensing cycle. Whirlpool WTW4950XW Washer won't go past the sensing cycle. It starts to spin to sense the load, then the lock flashes and unlocks. Starts to spin ...
washer. As it starts to spin back and forth it is sensing the load balance as the clothes fall back and forth. If it doesn't sense a balanced load because the clothes can't fall back and forth it will
washer Sensing light goes on, lid locks, makes some of the normal sensing noises, but then stops and lid lock light flashes. Last cycle didn't finish draining and spinning. When lid lock flashes, that
Question about GLTF2940ES Front Load Washer
washer is restarted. The sensing light may also come on during the Soak and Wash portions of the cycle. This is normal. If there's no water, then Page 13 Washer won't run or fill, washer stops working
...sensing My Samsung washer always begins its cycles by weight sensing the load -- but now it's stopped, unless its totally empty! And its being really finicky about running, sometimes it'll wash, ...
Question about GLTF2940ES Front Load Washer
...washer filling , stopping, sensing, filling ,stopping ,sensing repeatedly non stopsensing It overflows. But it will stop flowing start sensing and filling repeatedly Sensor fault. Possibly blocked ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions