Questions & Answers for: volvo 850 reverse

...i find the reverse light switch fo a 1996 volvo 850 turbo. Under the shifter console is where the older models are located. Sould be the same for the newer ones as well.It's just a small

...volvo 850 starts fine,when i put it in drive or reverse with my foot on the brake it stalls,if i put it drive without the brake it ok,if i step on the brake it stalls;what do you think? Sounds like ...

...Volvo 850. Car shakes when put into reverse My daughter just bought a 1997 Volvo 850. She started the car this morning and put it into reverse, and the car started shaking, and the check engine light ...

...VOLVO 850 green triangle next to the service button is a green triangle with a sorta reverse red check mark - does anyone know what this means that indicator is for the lambda sensor, that reverse ...

...volvo will go into reverse when you let it roll back a little my husband thinks it is some kind of sensor If it goes into reverse from park, it sounds like it's locking in place and linkage probably ...

volvo 850. Reverse will not work. Everything 1993 volvo 850. Reverse will not work. Everything else is fine. Is this a sensor or does the tranny need to be replaced? It would most likely be the tranny

...Volvo 850 Turbo. When it is in reverse, and if I step on the gas, the engine vibrates violently. You can feel the vibration throughout the entire car. It has no problem when it is in forward, only in ...

volvo has no reverse and maybe neutral YOU COULD HAVE FAULTY TRANSMISSION NEUTRAL SAFETY SWITCH BUT CHECK TRANSMISSION FLUID LEVEL MAKE SURE NOT LOW .IF ITS BEEN A LONG TIME. CHANGE TRANSMISSION FLUID

...volvo 850 auto I need to know where reverse light switch is located on Volvo 850 auto gearbox It's on the side of the transmission where the gear selection lever is. There will be a wiring harness ...

...volvo 850 glt There is a hatch over the Fuel Tank under the carpet. Pull the hatch off, disconnect the wires and hoses and unscrew the locking ring. pull the fuel pump and sending unit out as one ...