Question about Dimeblade Tribute Electric Guitar
volume dial off: it only plays one of the pickups and only when I push the toggle switch down. when the toggle is in the middle or top position there's no sound. Anyone have any suggestions and advice
...volume pot. chances are that one is broken. soldering around the area is ok but most likely there's an open circuit wih respect to the grounding of the volume pot Replace R507 with a 100 ohm ...
...volume pot. I have tried to purchase one I need volume pot. I have tried to purchase one from all the sony dealers, here in calgary, but I am told that they do not stock it any more. I tried to clean ...
...volume pot on a Gibson ES335.The best method for getting the old pot out of the guitar to enable it to be unsoldered and the new item to be soldered in it's place and put back into the guitar. If the ...
...volume pot is damaged. One other possibility is the soldering of a wire to the volume pot may be bad. If you are competent with a soldering iron you could replace the pot yourself or take it to a ...
...volume pot is bad or soldering of it is bad. Vibration will make things come and go. Look for broken solder around the pot leads first. Then look for a cracked circuit trace on the board near the ...
Question about M-116 Fullbore Metal Guitar Effects Pedal
...VOLUME POTS, but i don't know where to buy them, or the POT reference and spect to find a nice replacements. Thanks Usually with volume pots,the ratings dont matter. you can really buy then ...
Question about M-116 Fullbore Metal Guitar Effects Pedal
...volume pot up, if done slowly its not as bad but still makes a noise? If it ocours only when turning your volume pot then the pot is worn or dirty inside. I f you are handy get a new pot that is ...
...volume pot - alot of static crackling type noise when turned - what to do? If replace volume pot where to buy? If you have one of the older original pignose 7-100 amps the volume pot will be a 10k ...
pot (volume control) is dirty. with a slider you can normally get fluid down the side of the knob, your's is a rotary control and you sometimes can do it round the shaft of the pot but more often have
Usually answered in minutes!
297 Questions
192 Questions
155 Questions
161 Questions
136 Questions