Vestax PMC 05 PRO MIXER master output is not working More than likely the output PCB might be faulty, or the signal amp might be damaged. In either case, not an easy fix. As for service in the UK, try
...Vestax PMC-05 continually blows out. This is the third power supply that I have purchased (24.99-37.00) Sir, You are suggested to buy power stabilzer because some the thing which blows the power ...
mixer not working and board getting hot on the vestex mixer pmc2-05 replace the R106 resistor that was burn out but the ic chip is now getting hot and there is no power There is likely a voltage ...
...pmc 05 pro 4 has very low output. I can hear both right and left output channels in the headphones when I have the cue selected but when I try to monitor the master output the right output on the ...
power cord get really hot. If mixer is working properly, check the rating of the adapter versus what the unit requires. Some sites indicate this requires a 12 volt adapter rated at 1.2 amps.
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions