Questions & Answers for: vehicle shaking clicking

clicking noise while turning at higher speed. this is easy to confirm. raise and support the front of the vehicle and put in neutral. turn the wheels by hand with steering wheel pointed straight ahead

note before you take this vehicle in for an alignment fill it up with gas. This way suspension is loaded. Good luck The wheel shaking is probably your tire either being out of round or needs balancing

...vehicle is shaking and the alignment and tire pressure are fine, first check the fuses for the interior lights. As for the clicking sound in front tires - please provide further explanation as to the ...

...vehicle the car seems to not want to start right away now my car refuses to start it gives clicking noises when i start until it just goes silent. Sounds to me like you have a broken vacumn ...

...it shakes like the wheels are going to fall off. looks like you have aftermarket wheels on this vehicle. I would make sure the front wheels were balanced at a garage that has an up to date wheel ...

...shaking when braking at a speed higher than 60mph. braking at low speed is fine It can be issue with brake system alignment.Get the brake assembly checked.Something is not right and out of its way ...

...vehicle alignment. 10. Steering head bearings improperly adjusted. 11. Tire and wheel unbalanced. 12. Rims and tires are out-of-round or eccentric with the hub. 13. Rims and tires are out-of-true ...

...SHAKING AT 40 MILES PER HOUR TO 50 MILES P/HR WHEN ACCELERATING, IT STOPS WHEN NOT ACCELERATING i had the same problem with my olds. van it was a cv joint & a tie rod end When front wheel drive ...

shaking when accelerating I have a 2008 jetta, oil was low took it in to get it fixed, now oil light wont stop flashing, check engine light is on, rough acceleration and there is a click noise...I am ...

clicking sound comes from the under hood junction box. If you shake the box it starts right up until 3 months later and it doesn't it again. What exactly do you think needs to be replaced or checked?!