Questions & Answers for: valves intake valve 1985 chevy

valve covers are the same, the engine should fit. It would be easiest if both transmissions were identical but you can use a 350, 400 or even a 700r4 in there with some mods and a crossmember move and

Ad

valve it ran ok when i brouhgt but when i replaced everything it started smoking overheating dieseling and running rough. i did change all filters plugs and oil put on the cat and the muffler any help

Ad

...valve on the intake hose that goes thru the firewall. Check to see that the cable is connected and the valve is working. If it is working properly, the hose should become hot on the heater core side ...

Chevy 305 small-block engine runs good has a bad idle and dies when idling. I used a 350 intake and ignition system and put onto the 305 and need to know what to look for to make idle if this is a ...

Question about 1985 Corvette

1 Answer

...valve on my 1985 chevy van 305 engein with over drive Will have a steel line running from engine to rear or one side of the transmission just above the pan.,useing a rubber vacumn line to the ...

...dont force it). Turn the nut 1 full turn. Do Exhaust valves cylinders 1,3,4 and 8 and Intake valves 1,2,5, and 7. Rotate the motor one full turn and do Exhaust 2,5,6 and 7 and Intake 3,4,6 and

...then intake valve leaking. If comes out exhaust, you guessed it exhaust valve not closing. If comes out sump then bypassing rings. If comes out of radiator , head gasket leak into cooling ...

...chevy 305 start blowing white smoke so i checked oil and found water in it. but as i took off valve covers i found metal peices White smoke, coolant in the oil-you had a cylinder head gasket failure. ...

...chevy with a 305. it started blowing white smoke so i checked oil and found water in it. but as i took off valve covers i found metal peices I hate to be the bearrer of bad news, dude, but you have ...

valves from my 1985/1986 official shop manual: figure 6A1-39 valve stem and guide clearance max intake clearance 0.08 mm (0.0031 in) max exhaust clearance 0.10 mm (0.0039 in) pg 6A1-17 If clearance is

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...